K&H 3203 Assembly Instructions

Hangin' Cat Condo - 3 Story
Assembly Instructions
Thank you for purchasing the 3 Story Hangin' Cat Condo by K&H Pet Products.
Proper care and adjustment should lead to many years of pleasure for your cat.
ASSEMBLY & INSTALLATION INSTRUCTIONS:
Take the product out of the box and lay all parts on a flat surface.
1
You should have four metal brackets, rubber bumper/spacers, and a
3 Story Hangin' Cat Condo frame with built-in straps. See Figure 1.
Before installing the top two door brackets, first determine whether
2
you will need to use the bumper/spacers provided for the type of
door you will be using. Our unique door bracket system is made to
fit virtually any standard household door. For most thicker exterior
doors, i.e., front or back door of a home, the bracket can be used as
is. However, for thinner interior doors such as a bedroom or closet
door, we've provided stick-on silicone bumper/spacers to help remove
excessive gap between the bracket and the door. When using the
bumper/spacers, always determine first which side of the door your
new Hangin' Cat Condo will hang from.
NOTE: If the bumper/spacers are necessary, they should be attached
to the inside of the bracket OPPOSITE of the door jamb. See Figure
2 for CORRECT placement. (Never put the bumper/spacers on
the door jamb side of the bracket as this may prevent the door from
properly closing.) See Figure 3 for INCORRECT placement.
If the bumper/spacers are not needed, simply install the plain brackets
3
as is to the top of your door. See Figure 4 .
Once the top brackets are installed, slide the remaining 2 brackets onto
4
the bottom of your door. See Figure 5.
Hold the Cat Condo from its top two straps and hook the clips at the
5
end of the straps onto the top two brackets. See Figure 6.
Once the Condo is hanging from the top two brackets, hook the bottom
6
two clips to the lower two brackets. Pull the cinch strap lightly on the
right and left side just enough to slightly tighten the brackets to the
underside of the door. See Figure 7.
At this time, adjust the top and bottom brackets to the correct width
7
apart so the Cat Condo hangs straight and is centered on the door.
Step back and adjust the top, and/or bottom. Be sure it is visually
straight and where you want it. Lastly, firmly pull down on each cinch
strap to secure the Condo to the door. Figure 8 shows a good visual
of correct positioning of the bottom brackets and how the straps
should look once cinched firmly to the door.
The K&H 3 Story Hangin' Cat Condo will now keep your
cats busy for hours with plenty of places to play, hide, and lounge
for years to come. And don't forget its space-saving benefits!
Care Instructions: When the 3 Story Hangin' Cat Condo is
removed from packaging it is safe to steam in order to remove
unwanted wrinkles. To clean, wipe with a damp cloth.
K&H Pet Products with design is a registered trademark of Central Garden & Pet Company.
©2020 Central Garden & Pet Company
K&H Pet Products, Central Garden & Pet
www.khpet.com l (719) 591-6950
DOOR JAMB
BUMPER/
SPACER
INCORRECT
Figure 7
Made in China
Colorado Springs, CO
DOOR JAMB
BUMPER/
SPACER
CORRECT
REV0_05-05-20