Way Basics 819767011903 Manual

Cube, Cube Plus, and Rectangle Plus
CONNECT DOOR CUBE
Peel adhesive strips
on vertical zBoards
Included
8 Alignment Pins 2 Vertical zBoards
4 connectors pins adhesive strips on 2 edges
Double Cube Plus or Double Rectangle Plus
1 Bottom zBoard 1 Top zBoard
with door pin slot with magnetic door stopper
1 Backer Board 1 zBoard Door
thin and has no adhesive
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
Important
Tip Start assembly from bottom to top.
Connect
DO NOT place unit on its side or back as
it will compromise its structural integrity.
With Us
Watch and Assemble www.waybasics.com/help-door-cube
Place pins in each
vertical zBoards
• Assemble your unit on a flat even surface, carpet not recommended
• Furniture is for indoor use only
1
Carefully remove the 3M
protective layer from adhesive.
4
Align top zBoard.
talktous@waybasics.com
Help and Comments www.waybasics.com/contact
Align vertical zBoards
to horizontal zBoards
• When moving your Way Basics furniture, lift from the bottom
• Make sure zBoard surfaces are clean and dry
Triple Cube Plus or Tribeca
2
Place alignment pins in vertical
zBoards.
(Press)
5
Orient door properly as shown and
align bottom pin. Press on spring
loaded top pin and insert.
3
Align vertical zBoards and backer
board to bottom zBoard.
6
Join other connect cubes with
connector pins! Visit links below for
more details. Enjoy building possibilities!
Note Use included decals to cover the
connector holes if not stacking cubes.
Share Your Photos and Win
www.waybasics.com/share
Share and Win www.waybasics.com/share