CAT LITTER
Included
18 Pins
1 Scratcher
2 Side
1 Middle
1 Back zBoard
zBoards
zBoard
1 Top zBoard
2 Doors
1 Bottom zBoard
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
Important
CAUTION placing unit on its side or back
will compromise structural integrity. Use
right side up.
Help and Comments www.waybasics.com/contact
• Assemble your unit on a flat even surface
• Make sure zBoard surfaces are clean and dry
Back zBoard
Carefully remove the protective
1
layer leaving the 3M adhesive on
zBoard (adhesive shown in yellow).
Remove adhesive from side zBoards
4
and middle zBoard.
Align horizontal zBoard to unit as
7
shown. Press down firmly.
• When moving your Way Basics unit, lift from the bottom
• Indoor use only. Not in bathroom.
2
Insert alignment pins to back zBoard.
Insert alignment pins to side zBoards
5
and middle zBoard.
(Press)
(Press)
Orient door properly as shown and
8
align bottom pin. Press on spring
loaded top pin and insert.
3
Align back zBoard to horizontal
zBoard. Press down firmly.
Align vertical zBoards to horizontal
6
zBoard as shown. Press down firmly.
Place cat scratcher in unit.
9
Put your cat litter box inside doors.
version 042017
Need help?
Do you have a question about the 819767013648 and is the answer not in the manual?
Questions and answers