Rear Panel; Phantom Power; Guitar In; Guitar Thru - DigiTech VOCALIST LIVE 4 Owner's Manual

Vocal harmony and effects processor
Hide thumbs Also See for VOCALIST LIVE 4:
Table of Contents

Advertisement

Rear Panel

1.

Phantom Power

Enables 48 volt phantom power on the XLR mic input.
Note: Phantom power is normally only needed with condenser microphones and should
never be used with ribbon microphones. To avoid damaging the microphone, please consult
your microphone documentation to ensure phantom power is applied only when appropri-
ate.
2.

Guitar In

Connect a guitar directly to this high-impedance input. Note that there is no loss of quality
between the Guitar In and Guitar Thru jacks.
3.

Guitar Thru

Connect this output to the input of a guitar amplifier or powered speaker.
4.

Stereo/Mono

When Stereo is selected (Stereo Out LED is lit), the harmony voices are panned slightly
left and right, and certain effects (chorus, flanger, and reverb, for example) operate in stereo.
When Mono is selected (Stereo Out LED is not lit), the output mix is mono and the
outputs carry the same signal.
5.

Mic/Line Input Level

This knob adjusts the gain of the Mic and Line inputs. Turn clockwise to increase gain, or
counter-clockwise to decrease gain. If the Vocal Signal LED is turning red while you sing,
you need to decrease the Mic gain.
6.

Mic In

Connect a dynamic or condenser microphone to this XLR input. This input is the lead voice
for the Vocalist
7.

Expression Pedal

Connect an expression pedal here to control any parameter in the Effects matrix with your
foot. See the Utility Parameters menu on page 23 for more information.
8.

Line In

Connect a line input source (mixer, mic preamp, etc.) to this input. When connected to a
source, this input is the lead voice for the Vocalist Live 4, and disables the Mic In XLR input.
9.

Aux In

Plug in a CD or MP3 player to this /8" jack to add recorded music to the Vocalist Live 4
mix. Control the level with the CD or MP3 player's volume control.
10.

Guitar Ground Lift

Eliminates most "hum" problems. If you hear a humming sound or buzz coming from your
amp or P.A., try pressing this button.
1
Expression
Pedal
5
6
7
9
8
10
Live 4.
®
3
4
2
11
12
13
14
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents