Page 5
Assemble the fire pit base: Locate Door Pane D, 3 Side Panels E, and 2 Support Legs F. Screw O into the holes in the sides of all four including the legs pre-assembled to the door. Beginning with the Legs on the Door Panel D join the together by fitting the holes on the sides of the onto the installed earlier.
Page 6
Once all panels are bolted together,turn the table base upside- down,then attach Tank Support Bar to support Leg F and the Leg next to door latch by aligning the holes at each end of Tank Support Bar with the holes at the bottom of each Leg.Insert Bolt P through Washer Q then into holes.
Page 7
into Fire Glass Burner the pilot light housing. lace Burner Cover over the Burner. When unit is not in use and is completely cool, protect it with the included Protective Cover or any compatible fire pit cover.
Page 8
Connect hose and regulator to cylinder. The propane gas and cylinder are sold separately. Use a standard 20lb propane cylinder have this book. Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from the appliance. A cylinder must be stored outdoors in a well-ventilated area out of the reach of children.
Page 16
Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal. Frequently check for corroded areas and repair them promptly. Caution: before attempting service.
Need help?
Do you have a question about the Wagner 62988 and is the answer not in the manual?
Questions and answers