Quick Start - DigiTech RP-7 VALVE User Manual

Quick Start

For those of you who prefer to burn now and read later, we've included this Quick Start section to get you up and running.
Connect Cables:
Connect guitar into the Input jack (located on the rear of the RP-7 Valve). Now run from the Output of the RP-7 Valve to the Input of the
either the Guitar Amp, Power Amp or Mixing board.
Apply Power:
Note: When applying power to the RP-7 Valve, it is recommended that the <Output> knob be turned down prior to powering up the unit.
Adjust Output:
Now adjust the <Output > level knob on the rear panel of the RP-7 Valve to the desired output level.
Adjust Presence:
The <Presence> knob will act as a quick EQ. Use this knob to fine-tune your tone by turning clockwise (Brighter tone) or counter-clockwise
(Darker tone).
Select Preset:
Begin playing your guitar, and choose any preset by either pressing the <Program UP> or the <Program Down> buttons or by pressing the
bank <Up> and bank <Down> footswitches.
Jam-Along and Learn-A-Lick:
The RP-7 Valve will let you run a CD or Cassette tape signal into the signal of the RP-7 Valve so that you can play along with the music and even
use the Learn-A-Lick function for recording and playing back selected pieces of music. This can be done by simply running the CD or Cassette
headphone output into the Jam-Along jack (located on the rear of the RP-7 Valve).
II
RP-7 Valve
User Guide