Undo, Redo, And Clear; Undo An Overdub; Redo An Overdub; Clear Overdubs/Unstored Phrases - DigiTech JAMMAN STEREO Owner's Manual

Undo, Redo, and Clear

You can undo or redo an overdub anytime you remain in the current
memory where the overdub was recorded. You can also use a footswitch to
clear all unstored loop phrase audio.
Note: Changing loops discards any unstored overdubs. Storing the overdubs
will also remove the ability to undo or clear overdubs.

Undo an Overdub

Press and hold the
your last overdub. The
yellow and the display briefly shows ud when the undo takes place.

Redo an Overdub

Press and hold the
overdub; the
display briefly shows rd to indicate a redo has been performed.

Clear Overdubs/Unstored Phrases

Press and hold the
unstored recording/overdubs. The
display will show CL to confirm the clearing. If the loop had been previously
stored, the clear action will only clear unstored phrases and overdubs but
leave the original loop that had been stored untouched.
Changing to a different loop also clears any unstored phrases and overdubs.
32
Rec/PLaY/oVeRDUb
Rec/PLaY/oVeRDUb
Rec/PLaY/oVeRDUb
Rec/PLaY/oVeRDUb
teMPo/stoP
footswitch for two seconds to undo
and
oVeRDUb
footswitch to redo the last undone
and status LEDs flash yellow and the
oVeRDUb
footswitch for two seconds to clear the
status LED will flash and the
RecoRD
status LEDs flash