DigiTech JAMMAN STEREO Owner's Manual page 16

Guided Tour - Front Panel
6. Mic Level Knob
This knob controls the input signal level from the XLR Mic Input jack.
7. Peak LED
This LED lights when Instrument, Mic, or Aux Input signals are
detected by the JamMan
signal is present, yellow when approaching the A/D clipping point, and
red when clipping is present.
A good practice is to set the Inst Level and Loop Level controls
at the 12 o'clock position when using an electric guitar or bass.
This provides a unity gain signal through the JamMan Stereo when
connected to your amplifier.
For all other uses, set the Input Level controls so the green and
yellow LEDs light regularly but rarely lights the red LED. If the Aux
Input is being used, adjust the output level of the audio source to set
the input level appropriately.
8. Instrument Level Knob
This knob controls the input signal level from the Left (Mono) and
Right Input jacks.
9. Record Mode/Stop Mode LEDs
Inst/Mic (Stop) LED
This LED indicates the Instrument/Mic inputs are selected for
recording. When the Shift button is enabled, this LED will light when
the "Stop" stop mode is selected for the Loop (see page 36).
12
Stereo. This LED will light green when a
®