Noise Gate - DigiTech GNX1 User Manual

S T
ECTION HREE
Detuning is similar to a standard pitch shifter with the exception that it shifts the copied signal by less than a
semitone resulting in an effect as if two guitars were slightly out of tune and playing in unison.
Parameter 1 (Detune) - The Number 2 Knob selects the AMNT (Amount) of detuning applied to the copied
The number 3 and 4 Knobs have no function when Detune is selected.
A Pitch Shifter will keep the shifted pitch at a parallel distance from the input note.
Parameter 1 (Pitch) - The Number 2 Knob selects the SHIFT (Shift) of the pitch in semitone intervals. Ranges
The number 3 and 4 Knobs have no function when Pitch is selected.
Level - The Number 5 Knob adjusts the Level or Mix (IPSLVL/IPSMIX)of all pitch altering effects in this module.
Ranges from 0 to 99.
EQ
Equalization is an extremely useful tool used to further shape the tonal response of your guitar signal.The EQ in the
GNX1 is similar to the tone knobs on an amplifier with the exception that the GNX1 allows you to choose the center
frequency for the Mid Range and Treble adjustments.
EQ Green/Red - The Status button is used to select whether you are adjusting the EQ for the Amp Model assigned
to the Green or the Red Amp Channel when a Warped combination of amps is selected.
Bass Level - The Number 1 Knob adjusts the amount of low end enhancement. Ranges from G/R BASS -12 to 12
(dB).
Mid Frequency - The Number 2 Knob selects the frequency to which the boost will be applied by the Mid Level
knob. Ranges from 300Hz (300 Hz.) to 5000Hz (5000 Hz.)
Mid Level - The Number 3 Knob adjusts the amount of mid range enhancement. Ranges from G/R MID -12 to
12 (dB).
Treble Frequency - The Number 4 Knob selects the frequency to which the boost will be applied by the Treble
Treble Level - The Number 5 Knob adjusts the amount of high end enhancement. Ranges from G/R TRBL -12 to
12 (dB).

Noise Gate

A Noise Gate is designed to eliminate hiss and ambient noise while you are not playing. A Noise Gate can also be
used to create an automatic swell in volume.The GNX1 includes two different types of Noise Gates: Silencer™, and
Pluck.The Silencer™ operates as a standard Noise Gate.The Pluck Noise Gate is designed to close after every note
(depending on the Pluck Sensitivity).This allows automatic volume swells to occur on a note for note basis.
Gate On/Off - The Status button turns the Noise Gate on (GAT ON) and off (GATOFf).
Gate Type - The Number 1 Knob selects between the silNCR (Silencer ™) or PLUCK (Pluck) type of Noise
Gates.
Gate Threshold - The Number 2 Knob sets the signal strength required to open or close the Noise Gate.The
Gate Threshold (THRESH) parameter ranges from 0 (opens easily) to 40 (requires strong signals
to open).
Gate Attack - The Number 3 Knob adjusts the length of time it takes the gate to open (ATTACK) and the signal
to become audible once the Threshold has been exceeded. Ranges from 0 (immediate signal), to 9
(This setting will gradually ramp up the volume).
Pluck Sensitivity - The Number 4 Knob controls the point where the Gate retriggers (PLUCK) when using the
Pluck type Noise Gate.This Parameter is only available when Pluck is the selected type of Noise
Gate. Ranges from 0 (requires strong signals to retrigger) to 99 (retriggers with weak signals).
The Number 5 knob has no function when the Noise Gate is selected.
20
- E P
FFECTS AND
pitch in cents (100 cents equals 1 semitone). Ranges from -24 (24 cents below) to +24
(24 cents above).
from -24 (two octaves below) to +24 (two octaves above).
Level knob. Ranges from 500Hz (500 Hz.) to 8000Hz (8000 Hz.)
ARAMETERS