Selecting Amp/Cabinet Models; Adjusting Amp Parameters - DigiTech GNX1 User Manual

Selecting Amp/Cabinet Models

The first step to editing an Amp Model, Cabinet Type, or creating your own HyperModel™ is to select the Amp and
Cabinet types for the Green and Red Amp channels in your Preset.To do this, the GNX1 must be in the
Performance mode which is indicated by the LED next to the Status button lighting yellow. Pressing the Exit button
will return the GNX1 to Performance mode regardless of the currently selected mode.The procedure for selecting
an Amp Model or Cabinet Type for the Green or Red Amp Channels is as follows:
1. Use the Parameter 1 knob (far left) to select the Green Amp Model.The Amp Model name will appear in the
alpha-numeric Display. See the Amp/Cabinet Modeling section on page 12 for a complete list of Amp Models.
2. Use the Parameter 2 knob (second from the left) to select the Green Cabinet Type. See the Amp/Cabinet
Modeling section on page 12 for a complete list of Cabinet Types.
3. Use the Parameter 4 knob (second from the right) to select the Red Amp Model.
4. Use the Parameter 5 knob (far right) to select the Red Cabinet type.

Adjusting Amp Parameters

The Gain, EQ, and Level Parameters can be adjusted individually for the Green and Red Amp Channels.The Gain
ranges from 0 (0) to 99 (99).The Bass, Mid, and Treble EQ range from -12 (-12 dB) to 12 (+12 dB).The Level
ranges from 0 (0) to 99 (99).The procedure for adjusting the Amp Parameters is as follows:
1. Press the Status button until all horizontal LEDs across the columns light green.This indicates that you have
accessed the Amp Parameters for the Green Channel.
2. Use the Parameter 1 knob to adjust the Gain (distortion drive) for the Green Amp Channel.
3. Use the Parameter 2 knob to adjust the Bass (low frequency) enhancement for the Green Amp Channel.
4. Use the Parameter 3 knob to adjust the Mid range frequency enhancement for the Green Amp Channel.
5. Use the Parameter 4 knob to adjust the Treble (high frequency) enhancement for the Green Amp Channel.
6. Use the Parameter 5 knob to adjust the Level (volume) for the Green Amp Channel.
7. Press the Status button again until all horizontal LEDs across the columns turn Red indicating that the Amp
Parameters for the Red Channel have been accessed.Then repeat steps 2 through 6 for adjusting the Red Amp
Channel.
S T - E
ECTION WO
F
DITING UNCTIONS
13