Quick Start - DigiTech GNX1 User Manual

S O - I
ECTION NE

Quick Start

This Quick Start guide is included for those of you who would rather begin creating now and read about the
depths of the GNX1 gene pool later.
Making Connections:
Connect your instrument to the Input jack on the rear panel. Connect the Left /Right Outputs to the
input(s) of your amplifier(s), power amp, or mixer.
Apply Power:
Turn the Output Knob on the rear panel of the GNX1 all the way down (fully counter clockwise).
Connect the plug of the PS0913B power supply to the Power jack on the GNX1. Connect the other end
of the PS0913B power supply to an AC outlet and turn the GNX1 Power Switch to the on position.
Turn the power of your amplifier(s) to the on position and adjust the volume(s)to a normal playing level.
Gradually increase the GNX1 Output Knob to achieve the desired volume.
Select Output Mode:
To select the output mode, press the Utility button once and use the Data Up /Down buttons to
select either Stereo or Mono output mode.
Select Target System Setup:
The GNX1 needs to know the type of amplification system it will be used with. From the previous
Output selection step, press the Rhythm button once.This will take you to the Target System Setup
menu. Use the Data Up/Down buttons to select the amplification system you will be using the GNX1
with.Then press the Exit button to return the GNX1 to Performance mode.
Select Preset:
The GNX1 comes with 48 pre-programmed Factory Presets, and 48 User Presets. From the factory, the
User Presets are exact duplicates of the Factory Presets.This allows you to experiment without running
the risk of losing any of the original sounds contained in the GNX1.
Use the Bank Footswitch (9) to Select a Bank and the 1-3 Footswitches (1) to select different
Presets.The Data Up/Down buttons (7) can also be used to select a Preset. Once you have found
Presets that suit your taste, you can alter the sounds to your specific needs.Turning the Knobs (5) below
the Display will select Amp and Cabinet Models for the Green and Red Amp Channels.The Middle Knob
will Warp the two channels together. Pressing the Status button (4) will provide access to the Gain, EQ,
and Level Parameters for the Green and Red Channels.The Effects contained in each Preset can be edited
also. Press the Effect Select Up/Down buttons (3) to access and edit any of the effects.The Matrix
LEDs will light indicating which Effect has been selected. Follow the row with the lighted LED across to
determine which column the Parameter needing adjustment is located. Once a parameter has been
selected, you may increase or decrease the parameter value to your liking by rotating the Knob located
directly above the column for the desired parameter. Remember that you are not at risk of losing any of
the sounds the GNX1 came with so, don't be afraid to experiment.
2
NTRODUCTION