Advertisement
4
Compaq StorageWorks Model 4300 Family Ultra3 LVD Disk Enclosure
MA8000/EMA12000 Storage System
Installation
1. Be sure the enclosures are empty before mounting them into the rack. If necessary,
remove the following elements from the controller enclosure:
Environmental Monitoring Unit (EMU)
External Cache Batteries (ECBs)
If necessary, remove the following elements from the disk enclosure:
Power Supply/Blower Assemblies
Environmental Monitoring Unit (EMU)
Refer to the Compaq StorageWorks Model 2100 and 2200 UltraSCSI Controller User
Guide, Compaq StorageWorks Enclosure 4200 Family LVD Disk Enclosure User
Guide, and Compaq StorageWorks Enclosure 4300 Family LVD Disk Enclosure User
Guide the for further information.
2. Install brackets onto the controller enclosure and disk enclosures. Using two people,
mount the enclosures into the rack. Refer to the mounting kit documentation for
further information.
3. Install the elements. Install the disk drives (up to 12 disk drives in the Model 4314R
disk enclosures, or up to 14 disk drives in the Model 4354R disk enclosures). Make
sure you install blank panels in any unused bays.
WARNING: A shock hazard exists at the backplane when the controller enclosure
bays or cache module bays are empty.
Be sure the enclosures are empty, then mount the enclosures into the rack. DO NOT
use the disk enclosure handles to lift the enclosure. The handles cannot support the
weight of the enclosure. Only use these handles to position the enclosure in the
mounting brackets.
Use two people to lift, align, and install any enclosure into a rack. Failure to use two
people might cause personal injury and/or equipment damage.
CAUTION: Controller and disk enclosures have no power switches. Make sure the
controller enclosures and disk enclosures are physically configured before turning the
PDU on and connecting the power cords. Failure to do so can cause equipment
damage.
Power Supplies
Fans
Disk Drives
I/O Modules
Advertisement
