To Find The Three-Digit Code That Was Programmed Using The Auto Search Method - Universal Remote Control UR3-SR3 Operating Manual

STEP2
Press the [DEVICE] button and the [OK/SEL]
button simultaneously for three seconds. The
device LED will turn on indicating that it is ready
to be programmed. The LED will remain on for 20
seconds. The next step must be entered while
the LED is on.
STEP3
Press the [CH+] or [CH-] button one at a time or
keep it pressed. The remote will emit a series of
Power ON/OFF code signals. Release the [CH+] or
[CH-] button as soon as the equipment turns off.
*Note : You can verify that you selected the correct code
by pressing the [MUTE] button. The equipment
should turn On or Off.
STEP4
Press the same [DEVICE] button to store the
code. The Device LED will blink twice to confirm
that the code has been stored.
C. T o find the Thr
C. T o find the Thr
Pr ogrammed using the Auto Sear
Pr ogrammed using the Auto Sear
Method
Method
STEP1
Press the appropriate [DEVICE] button and the
[OK/SEL] button simultaneously for three
seconds. The device LED will turn on for 20
seconds. The next step must be performed while
the LED is on.
STEP2
Press the [INFO] button. The device LED will blink
a number of times indicating the number of each
digit for the code. Each digit is separated by a
one second interval of the LED being off.
Example : One blink, then three blinks, then eight blinks
indicates the code number 138.
*Note : Ten blinks indicates the number 0.
D. Pr ogramming a Second TV to the DVD Button
D. Pr ogramming a Second TV to the DVD Button
STEP1
Press the [DVD] button and the [OK/SEL] button
ee-Digit Code that W
ee-Digit Code that W
4
as
as
ch
ch