Advertisement
Advertisement
Table of Contents
Related Manuals for Minka minkaAire CONTRACTOR MINUTE F553L
Summary of Contents for Minka minkaAire CONTRACTOR MINUTE F553L
- Page 1 Model NO. F553L MINUTE...
- Page 2 ©2020 Minka Lighting Inc. Manual design and all elements of manual design are protected by United States Federal and/or State Law including Patents, Trademark, and/or Copyright Laws.
- Page 3 The warranty is void once the original purchaser or user ceases to own the fan or the fan is moved from its original point of installation. The warranty is void with the use of any hanger bracket (non-Minka Aire or non-fan specific) other than the hanger bracket supplied & installed with this specific fan.
- Page 5 Before you begin installing the fan, shut power off at the circuit breaker of the fuse box. Be cautious! Read all instructions and safety information before installing your new fan. Review accompanying assembly diagrams. Make sure that all electrical connections comply with local codes, ordinances, or National Electrical Codes.
- Page 6 (15+1 spare) (15+1 spare) 10. Cap 11. Finial (10+1 spare) 10.5...
- Page 7 ANGLED CEILING STRONG MAXIMUM 18° ANGLE proper blade clearance when installing on a steep, SUPPORT sloped ceiling. Longer downrods are available from your Minka-Aire ® dealer. HANGER OPENING must be To hang your fan where there is an existing fixture RECESSED...
- Page 8 The use of other parts, hardware or components not supplied ® by Minka Aire ® with the fan will void the Minka Aire Warranty. REMEMBER to turn off the power. Follow the steps below to hang your fan...
- Page 9 Slip coupling cover, canopy cover Step 5. and canopy onto downrod. (Fig. 9) Carefully reinstall hanger ball DOWNROD onto rod being sure that cross CANOPY pin is in the correct position, set screws are tighten and wires are CANOPY COVER COUPLING COVER not twisted.
- Page 10 Step 2. Connect the ground wire (Green or Bare Copper) to the ground wire from hanger ball and the ground wire from hanger bracket. (Fig.11) Fig. 11...
-
Page 11: Outlet Box
OUTLET BOX HANGER BRACKET HANGER BALL CANOPY CANOPY COVER Fig. 12... -
Page 12: Blade Holder
Step 1. Attach the fan blades to the holder bracket using the blade screws and fiber washers. Tighten the screws and fiber washers securely. (Fig.13) Step 2. Fasten the blade holder to fan motor assembly by using the blade holder screws. -
Page 13: Light Kit Assembly
CAUTION: To Reduce The Risk Of Electric Shock, Disconnect The Electrical Supply Circuit To The Fan Before Installing Light Kit. MOUNTING RING SCREW CONNECTION PLUG LIGHT KIT PLATE SCREW LIGHT KIT CONNECTION PLUG ASSEMBLY... -
Page 14: Glass Shade
Step1. Remove the rubber washer, metal washer, metal nut, metal cup and finial from the light kit assembly. Place glass shade over the light kit stem, secure with the rubber washer, metal washer, metal nut, metal cap and finial. Do not over tighten. - Page 15 The Reverse switch is located on the fan motor assembly (Fig.17). Slide the switch to the down for warm weather operation. Slide the switch to the up for cool weather operation.
- Page 16 WARNING! MAKE SURE THE POWER IS OFF AT THE ELECTRICAL PANEL BOX BEFORE YOU ATTEMPT ANY REPAIRS. REFER TO THE SECTION, “ELECTRICAL CONNECTIONS”.
- Page 18 0.06 2.48 9.27 2.404 0.58 37.12 3,490 1746 2.48 5029 37.12...
Need help?
Do you have a question about the minkaAire CONTRACTOR MINUTE F553L and is the answer not in the manual?
Questions and answers