Aeotec Lasso Sensor for Water Sensor 6 Quick Start

Aeotec
Aeotec Lasso Sensor for Water
Sensor 6
SKU: AEOEZWA007
Quickstart
This is a Z-Wave Device for . To run this device please connect it to your mains power supply.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer,
distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this
equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
What is Z-Wave?
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and
every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is
not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-
Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this
device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level
of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Product Description
The Aeotec Lasso Sensor is an innovative sensor that has no equal.
The product is connected to the Aeotec Water Sensor Dock (AEOEZW160) and detects even the smallest amounts of water over its entire length. The Aeotec
Lasso Sensor is suitable to cover whole areas and not only single points. This allows you, for example, to secure your washing machine over a large area by
moving the Lasso Sensor from the connection point to underneath the washing machine. This protects you from potential water damage over a wide area.
Water damage can easily be avoided - with the Aeotec Water Sensor 6 (AEOEZW122), the Aeotec Water Sensor Dock (AEOEZW160) and the Aeotec Lasso
Sensor.
Features:
Long sensor for the detection of very small quantities of liquid
Comprehensive detection possible
Can only be used in combination with the Aeotec Water Sensor Dock
Can be expanded several times and thus extended
Length: 1.45m
Prepare for Installation / Reset
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do
this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended
to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
manuals-backend.z-wave.info/make.php?lang=en&sku=AEOEZWA007&cert= 1/2