PRx Performance Build Limitless Half Rack Installation Instructions Manual

Download this manual

Tool List

• 15/16" Box End Wrench

• 15/16" Socket

• Ratchet or Impact Driver

Item #

Description

Upright

Multi-Grip Pull-Up Bar

Short Crossmember

Long Crossmember

5/8" Nylock Nut

5/8" Flat Washer

5/8" x 4-1/4" Hex Bolt

L - Foot or Angled Foot

5/8" x 4-1/2" Hex Bolt

J-Cup Pair

PRx Logo Plate

Logo Plate Backer

Floor Spreader Plate

5/8" x 4" Hex Bolt

WARNING

• Read all assembly, installation and use instructions in this manual prior to using this equipment.

• Inspect equipment prior to use. DO NOT use if it appears damaged or inoperable

• Use equipment only for the intended use DO NOT modify the machine

• DO NOT attempt to fix broken equipment. Call or email PRx Performance for assistance.

• SQUAT RACK MUST BE BOLTED TO THE GROUND

Save this manual for future reference.

Build Limitless Half Rack

Qty.

060325_Rev. 1

Need help?

Do you have a question about the Build Limitless Half Rack and is the answer not in the manual?

Page 1 • Inspect equipment prior to use. DO NOT use if it appears damaged or inoperable • Use equipment only for the intended use DO NOT modify the machine • DO NOT attempt to fix broken equipment. Call or email PRx Performance for assistance. • SQUAT RACK MUST BE BOLTED TO THE GROUND Save this manual for future reference.
Page 2 Rack Assembly (Rear): 1. Attach Short Crossmembers (3) and Long Crossmember (4) to the top of the rear Uprights (1) with the hardware shown. Figure 1, Detail A NOTE 1: Numbers and PRx logo at the top of the uprights are shown facing the rear of the rack. Customers can choose to rotate the uprights 180 degrees, so the logo and numbers are facing the front.
Page 3 Rack Assembly (Rear): Figure 1...
Page 4 Rack Assembly (Front): 1. Attach the front Uprights (1) to the front of the Short Crossmembers (3) with hardware shown. Figure 2 Details, C & D 2. Attach either the L-Feet or Angled Feet (8) to the front of the uprights with hardware shown. NOTE: L-Feet as shown in Figure 2 are to be used if purchased as a Functional Trainer.
Page 5 Rack Assembly (Front): Figure 3...
Page 6 Attach Logo Plate and J-Cups: 1. Attach PRx Logo Plate (11) and Backer Plate (12) with hardware shown. Figure 4, Detail F 2. Attach J-Cups (10) onto your uprights. Figure 4...