Suncourt AIRIVA Installation And Maintenance Instructions

Hide thumbs Also See for AIRIVA:

Advertisement

IMPORTANT WARNINGS
IMPORTANT SAFETY INSTRUCTIONS
WARNING To reduce the risk of fire or electrical shock, do not use
this fan device with a speed control of any kind. This device is for
general ventilating use only. Do not use with hazardous, toxic or
flammable vapors.
WARNING To reduce the risk of fire, electric shock or injury to
persons or animals, observe the following: Use this unit only in the
manner intended by the manufacturer. If you have any questions or
doubts, contact a qualified installer or Suncourt Inc.... Before servicing
or cleaning this unit, disconnect the power by unplugging it from the
110 -120 Volt AC outlet. If a suitable 110 -120 Volt AC grounded outlet
is not within reach of the Airiva power cord, a new outlet needs to be
installed. The installation of this outlet must be done by a qualified
person(s) in accordance with all applicable Codes and Standards.
The Airiva is equipped with a grounded plug. This safety feature
must never be defeated.
WARNING For your safety and protection follow all instructions and
adhere to applicable safety, building and electrical codes.
WARNING Install this product inside a building or dwelling only.
WARNING Do not operate this product without ductwork or approved
grilles being installed at the fan openings to prevent contact with the
fans. Contact with the operating fans will cause serious injury.
WARNING Do not install this product where it can come in contact
with water from flooding or otherwise.
WARNING Protect the outside vent hoods from ingress of water from
rain or otherwise.
WARNING Never expose this product to air temperatures over 120°F (49°C).

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AIRIVA and is the answer not in the manual?

Questions and answers

Summary of Contents for Suncourt AIRIVA

  • Page 1 110 -120 Volt AC outlet. If a suitable 110 -120 Volt AC grounded outlet is not within reach of the Airiva power cord, a new outlet needs to be installed. The installation of this outlet must be done by a qualified person(s) in accordance with all applicable Codes and Standards.
  • Page 2 If moisture collects in the bottom of the Airiva™, You should install the drain. You will need to make a 5/8" diameter hole in the bottom of the Airiva™...
  • Page 3 When connected to the air supply trunk duct of your forced air system, the air velocity through the heat exchanger of your Airiva™ will be lower for the short periods your forced air system operates. This will not significantly affect the system efficiency over a 24 hour period.
  • Page 4: Frost Protection

    Airiva™ and may cause freeze up. Connect the fresh air to house output of the Airiva™ to the return duct of the forced air system with 6" of duct pipe.
  • Page 5: Manufacturer's Warranty

    Switch the Airiva™ 'on' at high speed. Measure the air velocity at the fresh air intake or fresh air output duct of the Airiva™. Adjust the damper to match the air velocity (FPM) in the stale air path to the FPM observed in the fresh air path. You may also balance the airflow paths by measuring the static pressure using a manometer or magnehelix.

Table of Contents