OPERATION INSTRUCTIONS FOR THE FLUSH FIT™ REGISTER BOOSTER™
MODEL: HC500
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT NOTICE
With the use of any electrical appliance, it is important to observe all basic precautions to
minimize the risk associated with use, such as electrical shock, fire, or injury to persons. Read
these instructions before using your Flush Fit™ Register Booster™.
NEVER EXPOSE YOUR REGISTER BOOSTER™ TO TEMPERATURES OVER 140°F
(60°C)
INSTALLATION
DO NOT INSTALL IN CEILING.
FLOOR REGISTER 4" X 10"
1. Plug the small molded end of the power cord into the top of the Flush Fit™ Register
Booster™.
2. Plug the wall transformer end of the power cord into a 120 Volt AC outlet.
3. Follow directions for operation settings before placing in register.
4. Remove floor register and replace with the Flush Fit™ Register Booster™.
WALL REGISTER 4" X 10"
1. Drill (two) holes with a 3/16" drill bit from the bottom side of the Flush Fit™ Register
Booster™grille. The holes should be drilled in the pre-molded location as pictured below.
2. Plug the small molded end of the power cord into the top of the Flush Fit™ Register
Booster™.
3. Plug the wall transformer end of the power cord into a 120 Volt AC outlet.
4. Follow directions for operation settings before placing in register.
5. Remove the wall register and replace with the Flush Fit™ Register Booster™.
6. Secure the Flush Fit™ Register Booster™ in place.
Need help?
Do you have a question about the FLUSH FIT REGISTER BOOSTER HC500 and is the answer not in the manual?
Questions and answers