RHINO 2409 Operator's Manual page 91

PROBLEM
Insufficient lift capacity
Excessive wear on bucket
cutting edge
Bucket cutting edge not
flat on theground.
2409 01/11
© 2011 Alamo Group Inc.
OPERATION
POSSIBLE CAUSE
Load is greater than boom
lift capacity.
Improper hydraulic pump
operation.
Internal lift cylinder leakage.
Improper hydraulic valve
operation.
Bucket is riding on cutting
edge instead of wear runners.
Rear axle on tractor not level
from side to side
Operation Section 4-45
REMEDY
Check loader specifications.
Repair or replace pump.
Replace any worn parts and install
a seal repair kit. See "Cylinder
Service".
Repair or replace valve.
Use boom "FLOAT" position or
bucket level indicator to ensure
bucket rides
With tractor on level surface,
compare rear axle height from left to
right, measuring from axle center to
ground. Adjust air pressure in rear
tires until axle height measures the
same for both sides.