Related Manuals for FLYFINE FBA5120B
Summary of Contents for FLYFINE FBA5120B
- Page 1 User Manual Single Phase Off Grid All In One ESS FBA5120B/FBA10240B/FAB15360B/FAB20480B User Manual...
-
Page 2: About This Manual
Change History About This Manual Changes between document issues are cumulative, meaning that each subsequent document issue includes all The manual primarily encompasses product information, along with installation, operation, and maintenance guideline. the changes made in earlier issues. It will refer to the device as the “ESS” unless otherwise specified. Target Group V1.0(2024-08-20) This manual is intended for professional technicians who have responsibilities for the installation, operation, and... -
Page 3: Table Of Contents
Contents User Manual User Manual flyfine 1 Safety Instruction 7 System Decommissioning 1.1 Unpacking and Inspection 7.1 Disconnecting the ESS 1.2 Installation Safety 7.1.1 Disconnecting the ESS 1.3 Electrical Connection Sfety 7.1.2 Dismantling the ESS 1.4 Operation Safety 7.1.3 Disposal of the ESS 1.5 Maintenance Safety... -
Page 4: Safety Instruction
User Manual User Manual flyfine flyfine 1. Safety Instructions 1.1 Unpacking and Inspection Before using please read all instructions and cautionary markings on the unit and this manual. Store the manual WARNING where it can be accessed easily. Before decommissioning the device, carefully inspect all safety signs, warning labels, and nameplates to ensure This manual is for qualified personnel. -
Page 5: Operation Safety
User Manual User Manual flyfine flyfine Avoid contact with any terminals of the ESS while it is running to prevent electric shock. DANGER Do not disassemble any parts of the ESS while it is running, as it may result in electric shock. -
Page 6: Product Description
Do not ground the positive or The model description is ws (take FBA5120B as an example): negative terminals of the solar panel. A simple schematic diagram of a typical energy storage system is shown in FBA5120B: All-in-one Energy Storage System Figure 1. -
Page 7: Led Panel
User Manual User Manual flyfine flyfine LCD Setting Dimensions After pressing and holding ENTER button for 3 seconds, the unit will enter setting mode. Press “UP” or “DOWN” button The following table shows the dimensions of the ESS. to select setting programs. And then, press “ENTER” button to confirm the selection or ESC button to exit. - Page 8 User Manual User Manual flyfine flyfine Solar energy is charged first and AGM(default) Flooded SUB priority then power to the loads. If solar energy is not sufficient to power all connected loads, Utility energy will supply power to the If “User-Defined” is selected, loads at the same time.
- Page 9 User Manual User Manual flyfine flyfine If this inverter/charger is working in Line, Standby or Fault Auto bypass auto manual(default) mode, charger source can be programmed as below: When selecting “auto”, if the mains power is Solar energy will charge normal, it will automati- Solar first...
- Page 10 User Manual User Manual flyfine flyfine If self-defined is selected in program 5, this program can Mode4(default) be setup. Floating charging The buzzer sounds when Default 54.0V, setting range is from 48.0V to the value of voltage there is a fault...
- Page 11 User Manual User Manual flyfine flyfine Buzzer mode Buzzer mode Disable automatic activation (default) Battery equalization When Program05 is selected “LIx” as lithium battery and when Automatic activation If “Flooded” or “User-Defined” is selected in program 05, for lithium battery the battery is not detected, the this program can be set up.
-
Page 12: Setting For Lithium Battery
User Manual User Manual flyfine flyfine 2.5 Battery 2.4 Setting for Lithium Battery Lithium Battery Connection 2.5.1 BMS Comm. Address If choosing lithium battery for the inverter, you are allowed to use the lithium battery only which we have After all wiring installation is complete, set up ID for each battery module. The ID code for each battery module MUST configured. -
Page 13: Soc Indicator& Status Indicator Guides
User Manual User Manual flyfine flyfine BMS LED Status Mode: RS232 upright RJ11 socket O: LED OFF RJ11pin defined declaration RJ11pin defined declaration F1: LED Flash1 Communication F2: LED Flash2 with host F3: LED Flash3 computer L: LED Light REMARK... -
Page 14: Unpacking And Storage
User Manual User Manual flyfine flyfine If any issues or discrepancies are found during the inspection, refrain from installing the device and immediately NOTICE contact your distributor for assistance. If the problem persists or your distributor is unable to resolve the issue, The suggested parameters provided in this section are subject to updates and revisions as a result of product promptly reach out to us for further support. -
Page 15: Mechanical Mounting
User Manual User Manual flyfine flyfine NOTICE It is crucial to store the ESS in accordance with the specified storage requirements. Failure to meet these requirements may result in product damage, and it's important to note that such damage caused by improper storage is not covered by the warranty. -
Page 16: Installation Tools
User Manual User Manual flyfine flyfine Ensure that the ambient temperature and relative humidity of the installation site meet the specified requirements. 4.3 Installation Tools To prolong the service life of the ESS, avoid direct exposure to sunlight, rain, and snow. Consider installing them in Installation tools include but are not limited to the following recommended ones. -
Page 17: Installing The Ess
User Manual User Manual flyfine flyfine 4.5 Installing the ESS Step 3 : After marking the wall with a marker, remove the battery pack. Drill a hole with a diameter of 10 on the wall using an impact drill, with a depth of 60MM. Knock the yellow rubber plug into the hole. Move Note: the battery to the perforated wall and secure it with screws. - Page 18 User Manual User Manual flyfine flyfine Step 8 : Connect the battery modules through a busbar connector as shown in the diagram. Before connecting, Step 5 : Install the positioning accessories on the top surface of the battery pack. Then fix the ESS hanger to the ensure that the battery pack is turned off.
-
Page 19: Electrical Connection
User Manual flyfine flyfine User Manual 5. ELectrical Connection 5.2 Utility Grid Connection 5.2.1 Preparation 5.1 Safety Instructions Before connecting to AC utility, please install a separate AC circuit breaker between surge protection device (SPD) DANGER and AC utility. This will ensure the ESS can be securely disconnected during maintenance and fully protected from over current of AC input. -
Page 20: Pv Module(Dc) Connection
User Manual flyfine User Manual flyfine Step 5 : Connect wires according to the polarities indicating on terminal block. Be sure to connect PE protective Solar Charging Mode conductor (G) first. INVERTER MODEL 6.2KVA L→LINE (brown or black) Max. PV Array Open Circuit Voltage 500DC N→Neutral (blue or white) -
Page 21: Commissioning
User Manual flyfine flyfine User Manual 6. Commissioning Output short circuited. 6.1 Inspection before Commissioning Output voltage is too high. Before starting the ESS, please ensure the following checklist items are checked: Confirm that all equipment has been installed securely and in accordance with the manufacturer's Overload time out instructions. -
Page 22: Warning Indicator
User Manual User Manual flyfine flyfine 7. System Decommissioning 6.4 Warning Indicator 7.1 Disconnecting the ESS Warning Event Warning Code Audible Alarm Icon flashing 7.1.1 Disconnecting the ESS Beep three times every CAUTION Temperature is too High second To ensure safety and prevent the risk of burns, it is important to follow proper procedures when operating or performing maintenance on the ESS. -
Page 23: Decommissioning The Battery
9.1 Technical Data Certain components of the ESS may pose a risk of environmental pollution. Please adhere to the disposal regulations for electronic waste that are applicable at your installation site when disposing of these components. MODEL FBA5120B FBA10240B FAB15360B FAB20480B 7.2 Decommissioning the Battery...
Need help?
Do you have a question about the FBA5120B and is the answer not in the manual?
Questions and answers