Operating Instructions - Marmitek POWERMID XL Operating Instructions Manual

1. Plug the POWERMID XL Transmitter into a 220V/240V outlet in the room
where you want to use your remote control (up to 20 feet/6 meters away from
where you normally sit). Make sure the front of the unit (with POWERMID
name) is facing you. Fully extend the antenna.
2. Plug the POWERMID XL Receiver into a 220V/240V outlet in the room
where your TV, VCR, Stereo, etc. is located (up to 20 feet/6 meters from it).
Point the front of the Receiver towards the TV, VCR, stereo etc. Fully extend
the antenna.
3. Point your remote control at the POWERMID XL Transmitter. It receives the
signals and transmits them to the POWERMID XL Receiver. The POWERMID
XL Receiver then re-transmits these infrared signals to your TV, VCR, stereo,
etc.
Add more Transmitters to use your remote controls in several rooms.
Add more Receivers to control equipment in different rooms.
Add an Infrared Extender (sold separately) if you need to place the
POWERMID XL Receiver next to your equipment instead of in front of it, or if
your equipment is located inside a closed cabinet.
Note: The Transmitter and Receiver will most likely be in different rooms
(up to 100 feet/30 meters away). The range is depending on:
1. The number of floors and walls the signal has to travel through and
material these walls and floors are made of.
2. Other 433MHz sources (e.g. wireless head phones, wireless speakers) can
effect the range of the PowerMid XL. The best range will be achieved when
these sources are switched off while using the PowerMid XL. Cordless
phones will not affect the PowerMid XL.
3. Some satellite receivers require more careful positioning of the Powermid
system. If any difficulty is encountered, try to move the Powermid
(Receiver) a little to various positions until it operates correctly.

OPERATING INSTRUCTIONS

1