Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Cama Handi-lift EA6
Summary of Contents for Cama Handi-lift EA6
- Page 1 HOW TO Install safety edges according to EN81-40 on EA6...
-
Page 2: Table Of Contents
Handi-lift EA7 Table of contents Introduction Preparation. 2.1 Parts 2.2 Tools Step by step 3.1 Mark up the installation holes 3.2 Install the safety edges 2020 Page 2... -
Page 3: Introduction
Handi-lift EA7 1 Introduction If you for some reason must install safety edges on the EA6, the description below is explaining how you must carry out this operation. 2 Preparation. Before you install the new overspeed governor please read these instructions carefully. Check that you have all the necessary parts and tools to perform the operation. -
Page 4: Parts
Handi-lift EA7 2.1 Parts Safety edges 2.2 Tools 13 mm spanner Allen key 3-2,5 mm Power drill Screwdriver Ratchet with top 13 mm Drill 4-20 mm 2020 Page 4... -
Page 5: Step By Step
Handi-lift EA7 3.2 Install the safety edges Insert rubber plugs: Now install the safety edges in the holes: 2020 Page 6... - Page 6 Handi-lift EA7 Fasten it at the bottom with 2 Allen screws: Install the brackets on the back side of the cover: 2020 Page 7...
- Page 7 Handi-lift EA7 The wires are installed: Remove wire and insert the wires from the safety edges. Remove this wire The installation is now complete, and you are ready to test if the safety edges are working as they should. 2020 Page 8...
Need help?
Do you have a question about the Handi-lift EA6 and is the answer not in the manual?
Questions and answers