Hyundai S8F37 AB000 Quick Start Manual

Copy OEM Logo Here (→)
Electronic Installation Instructions
If this is a printed copy of the installation instructions, ensure you have the latest revision by
scanning the QR code or by entering the website address listed below before beginning
installation. Use the latest revision date as noted by "Rev. Date" above.
Entered by MPA
www.hyundaiaccessories.com/admin_media_uploads/installationSheets/s8f37_ab000.pdf
Application Notes
Front Mudguards are not compatible with Side Steps. If Front Mudguards are equipped,
Instructional Symbols / Definitions
Denotes warnings that may lead to serious
physical injury or vehicle damage
Denotes cautions to be taken to avoid
physical injury or electronic component
damage
Denotes cautions to be taken to avoid
vehicle and component damage
Basic Required Tools
Right-Angle #2
Drop Cloth (Large)
Phillips Bit Driver
Ratchet Utility Knife
Rivet Gun Drill Stop
Part Weight (Gross) FMVSS 110 Compliance Information
All dealers must determine if the Net weight they have added in the form of all options or accessories, when added to the weight of all Port/Dealer Installed
30.07
lbs
options or accessories, exceeds the lesser of 1.5% of GVWR or 100 lbs. If the additional weight does exceed the lesser of the indicated thresholds, a "Load
Carrying Capacity Reduced" label must be installed. A black, fine-point, indelible marker must be used to write by hand onto the label, the reduced carrying
13.64
capacity in kilograms or pounds, which is the total weight of all added options and accessories.
kg
Load Label Part Number: NP070 - 09003
Part Weight (Net)
24.10
lbs
10.93
kg
Notes to the installer:
1) Read the entire Installation Instructions prior to beginning the installation of this accessory.
2) If applicable, scan the barcode label located on the accessory part or packaging prior to installing, to register the part. If this accessory is installed as
a replacement, register the removal of the old part before registering the new part. Old and new parts will have different barcode data, and the old
registration cannot be reused.
3) Make sure the vehicle is completely clean and dry in the area(s) the part is to be installed.
4) Ensure the vehicle is properly protected in the area(s) that the accessory is to be installed.
5) NEVER place tools on painted surfaces, seating surfaces, dash pad, console or floor carpet/mats.
6) Always wear appropriate personal protective equipment, including gloves, safety glasses, etc., when required.
7) Do NOT use a two-post vehicle lift for side step installation.
Genuine Accessories
Vehicle Model: Palisade
Model Year 2020~
Part No. S8F37 AB000
Language English
Rev. Date 2/6/2020
they must be uninstalled prior to Side Step installation.
Denotes quality processes to be checked
prior to moving to the next step
Denotes specific tools that are necessary
to complete a step
N
O
Denotes important information to be
T reviewed during the step
E
Plastic Trim
Torque Wrench
Removal Tool
50/50 Mix Of
Needle-Nose Pliers Isopropyl Alcohol
(70%) & Water
Revision Date
02/06/2020
Accessory: Side Steps
Difficulty: ( B )
Note: Difficulty stated above reflects the minimum level of
expertise required to install the accessory:
(A) Customer
(B) Dealer Technician
(C) Master Technician or Specialist
Denotes personal protective equipment (PPEs) that
may be required for a step. Examples of safety
equipment icons noted below:
Glasses
Mask Hearing Protection
Clip Removal Tool Extension
Clean Towel Drill
Gloves
10mm Socket
5mm (3/16")
Drill Bit
Page 1 of 8