Maintaining; Specifications - Insignia NS-CLVR01 User Manual

Clock radio with voice command
Hide thumbs Also See for NS-CLVR01:
Table of Contents

Advertisement

Problem
Cause/Solution
The clock radio
This is common in English. For example, it is common to confuse
confuses
nine and five. Try again. Speak loud and clear near the MIC on top of
numbers when
the clock radio.
setting the time
or alarm
The clock
The back-up batteries are not installed correctly, not installed, or
resets to
dead. Check or replace the back-up batteries. And then set the clock
"12:00"
again.
No sound from
Make sure the external device is connected correctly and the clock
an external
radio is in AUX mode.
sound source

Maintaining

Cleaning your clock radio
To clean your clock radio, follow these guidelines:
Use a soft, clean cloth moistened with plain, luke-warm water
to clean the exterior of your clock radio.
Do not let liquid drip into the inside of your clock radio.
For stubborn stains, use a soft cloth dampened with a weak
solution of mild detergent and water. Dry your clock radio
immediately afterwards with a clean cloth. Do not use abrasive
clothes, thinners, alcohol, or other chemical solvents, because
they may damage the finish or remove the panel lettering.

Specifications

Specifications are subject to change without notice.
Frequency range
Station presets
External connections 3.5 mm stereo
Volume
Speakers
18
Insignia NS-CLVR01 Clock Radio with Voice Command
Note: Always pronounce "0" as "oh" instead of "zero." For example, if you
want to set the time at 11:05 PM, you should say "Eleven oh five PM."
Bands:
Range:
FM - 5
AM - 5
0-16 levels
2 x 2" - 4 ohm full range
2W x 2 RMS
www.insigniaproducts.com
FM and AM
FM - 87.5~107.9 MHz (200 KHz steps)
AM - 530~1710 KHz (10 KHz steps)

Advertisement

Table of Contents
loading

Table of Contents