Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP Hardware Installation Manual page 125

Appendix F Priming Lightweight Access Points Prior to Deployment
Step 6 If the operating system download is successful, the access point reboots. Normal operation is indicated
when the radio LED is blinking to indicate radio activity.
Step 7 Use the controller CLI, controller GUI, or Cisco WCS to configure the access point with primary,
secondary, and tertiary controller names.
Step 8 If the access point is in a Controller Mobility Group, use the controller CLI, controller GUI, or Cisco
WCS to configure the Controller Mobility Group name.
Use controller CLI, controller GUI, or Cisco WCS to configure the access point-specific 802.11a,
Step 9
802.11b and 802.11g network settings.
If the configuration priming was successful, the radio LED is blinking to indicate normal operation.
Step 10
Repeat Steps 4 to 9 for each access point.
Step 11
When you successfully complete the configuration priming of all your access points, ensure Master
setting is disabled on your controller. Also you can begin deploying the access points to their final
destinations.
OL-8370-04
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
F-3