Browser Tftp Interface; Obtaining The Access Point Image File - Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP Hardware Installation Manual

Chapter 6 Troubleshooting Autonomous Access Points

Browser TFTP Interface

The TFTP interface allows you to use a TFTP server on a network device to load the access point image
file. Follow the instructions below to use a TFTP server:
Step 1 Open your Internet browser.
Note
Enter the access point's IP address in the browser address line and press Enter. An Enter Network
Step 2
Password screen appears.
At the prompt, enter the administrator username and password. The default username is Cisco and the
Step 3
default password is Cisco. The username and password are case sensitive. The Summary Status page
appears.
Click the System Software tab and then click Software Upgrade. The HTTP Upgrade screen appears.
Step 4
Click the TFTP Upgrade tab.
Step 5
Enter the IP address for the TFTP server in the TFTP Server field.
Step 6
Enter the file name for the access point image file (such as c1200-k9w7-tar.123-8.JA.tar) in the Upload
Step 7
New System Image Tar File field. If the file is located in a subdirectory of the TFTP server root directory,
include the relative path of the TFTP server root directory with the filename. If the file is located in the
TFTP root directory, enter only the filename.
Click the Upload button.
Step 8
When a message appears that indicates the upgrade is complete, click OK.
Step 9
For additional information click the Help icon on the Software Upgrade screen.

Obtaining the Access Point Image File

Your access point must be running specific Cisco IOS software releases before you upgrade its radios;
Caution
otherwise your access point might not be able to complete the boot sequence until the radio is removed
(see
Cisco Aironet Access Points.
Table 6-3
Radio Upgrade
IEEE 802.11g
RM21A or RM22A
OL-8370-04
The access point web-browser interface is fully compatible with Microsoft Internet Explorer
version 6.0 on Windows 98 and 2000 platforms, and with Netscape version 7.0 on Windows 98,
Windows 2000, and Solaris platforms.
Table 6-3). For additional information, refer to the Cisco IOS Software Configuration Guide for
Required Cisco IOS Software Release
Required Cisco IOS Software Release
12.2(13)JA or later
12.3(2)JA or later
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Obtaining the Access Point Image File
6-11