Graco 224-909 Instructions-Parts List

This manual contains IMPORTANT
WARNINGS AND INSTRUCTIONS
READ AND RETAIN FOR REFERENCE
H.E.L.P. 1600 GUN
REMOTE FAN VALVE KIT
Part No. 224–909
WARNING
Pressure Relief Procedure
To reduce the risk of serious bodily injury, including
splashing in the eyes or on the skin, follow this pro-
cedure before installing the kit.
1. Turn off the air and fluid supply to the gun.
2. Trigger the gun into a grounded metal waste
container to relieve air and fluid pressure.
1. Follow the Pressure Relief Procedure Warning,
at left.
2. Remove the gun's standard fan adjusting valve.
3. Install the remote fan valve kit.
4. Connect an air line to the valve's 1/4–18 npsm fitting.
5. Refer to the graphs below and the T ypical Spray Pat -
tern Size information on the back of this sheet to set
the fan air line pressure for the desired pattern.
Atomization Pressure and Air Flow
Cap Pressure
Air Flow
Compliant
Spraying
Atomizing Air Inlet Pressure (psi)
NOTE: Maximum atomizing air inlet pressure
for compliant spraying is 26 psi (1.8 bar)
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441
COPYRIGHT 1992, GRACO INC.
308–210
Rev. A
Remote Fan Valve
Kit
Part No. 224–909
Horn Pressure and Air Flow
Cap Pressure
Air Flow
Compliant
Spraying
Remote Fan Air Inlet Pressure (psi)
NOTE: Maximum remote fan air inlet pressure
for compliant spraying is 34 psi (2.3 bar)