I-Pi Idle-Up Pitch Curve Function; Hold Throttle Hold Function - FUTABA 6EX-2.4GHZ Instruction Manual

3. Use SELECT key to select the desired curve point. Point 1 is shown initially which is throttle
stick's all the way downward (slow) position. Point 5 is throttle stick's all the way upward (hi)
position.
4. Push up or down DATA INPUT lever to set the servo position.
5. Use SELECT key to set other points in same manner.
I-PI Idle-up pitch curve function: (HELI only)
Used to set pitch curve for idle up flight. 5-point pitch curve is utilized to best match the blade collective pitch to the consistent
engine RPM when idle up is used. Pitch curve can be adjust from 0-100% each point.
The high side pitch curve should be set to not overload the engine and keep consistent engine RPM. Generally, set less pitch
than normal maximum pitch. The low side pitch curve should be set for desired maneuvers such as loops, rolls, and 3D flight.
To set the idle-up pitch curve:
1. Enter the programming mode and use the MODE key to access the "I-PI" function.
2. This is the idle up pitch curve, to use this function the "I-TH" Idleup throttle function must be
activated first.
3. Use SELECT key to select the desire curve point. Point 1 is shown initially, which is the
throttle stick's all the way downward (slow) position. Point 5 is the throttle stick's all the way
upward (hi) position.
4. Push up or down DATA INPUT lever to set the servo position.
5. Use SELECT key to set other points in same manner.
HOLD Throttle hold function (HELI only)
Throttle hold function is to be used for autorotations where only pitch control is used to make
a descent and landing. Just flip the hold switch on to set the engine in the idling or cut position
and disengage it from the Throttle Stick. It can be set from (-)50 to (+)50% from throttle trim
position.
To set the throttle hold:
1. Enter the programming mode and use the MODE key to access the "HOLD" function.
2. Push the DATA INPUT lever upward for 0.5 seconds. This will cause the flashing "INH"
display to change to a flashing "OFF" or "ON" display. Now the "HOLD" function is on.
("OFF": if the throttle hold switch is off, "ON": if the throttle hold switch is on.)
3. Push SELECT key once. This will cause the flashing "%" symbol on the display. Pull the hold
switch towards you. Push up or down DATA INPUT lever to set the throttle servo position of
throttle hold.
25