FUTABA 4PL-2.4GHZ Instruction Manual page 83

a
-Select the setting item "MODE" by (UP) or (DN) button,
and select "READ" by (+) or (-) button.
b
-Select the setting item "EXEC" by (UP) or (DN) button,
and press the (+) and (-) buttons simultaneously for 1 second
or longer.
-"COMPLETE!" blinks on the screen and the ESC type and currently set
contents are read.
- If "LINK ERROR" blinks on the screen, communication with the amp is not
being performed normally. Check the T4PL and ESC connection and the bat-
tery connection to ESC and the ESC power switch and repeat steps a b.
3
(Writing to ESC)
Execute this function to write the setting data to ESC. See
pages 84~85 for the setting data contents.
a
-Select the setting item "MODE" by (UP) or (DN) button,
and select "WRITE" by (+) or (-) button.
b
-Select the setting item "EXEC" by (UP) or (DN) button,
and press the (+) and (-) buttons simultaneously for 1 second
or longer.
-"COMPLETE!" blinks on the screen and the setting data is written to ESC.
If "LINK ERROR" blinks on the screen, communication with the amp is not
being performed normally. Check the T4PL and ESC connection and the bat-
tery connection to ESC and the ESC power switch and repeat steps a b. In
addition, if (NO DATA) is displayed on the T4PL screen, "WRITE" cannot be
selected because there is no setting data to be written.
- Different type ESC data cannot be written. If writing is attempted, "TYPE
ERROR" will link on the screen to show that the ESC type is wrong.
4
(Initialization)
This function writes the MC setting data set at the factory to
the connected MC and T4PL. Perform "READ" before per-
forming initialization.
a
-Select the setting item "MODE" by (UP) or (DN) button,
and select "RESET" with the (+) or (-) button.
b
-Select the setting item "EXEC" by (UP) or (DN) button,
and press the (+) and (-) buttons simultaneously for approxi-
mately 1 second
- "COMPLETE!" blinks on the screen and the initial data is written to the ESC.
If "LINK ERROR" blinks, communication with the amp was not performed
normally. Check the T4PL and ESC connection and the battery connection to
ESC and the ESC power switch, and repeat steps a b. In addition, when (NO
DATA) is displayed on the T4PL screen "RESET" cannot be selected because
there is no write initial data.
ESC Link Function "MCLNK"
83