Receiver Terminology; Connectors; How To Link The Transmitter And The Receiver - FUTABA 4PL-2.4GHZ Instruction Manual

Receiver Terminology

Antenna Coaxial cable

How to link the transmitter and the receiver

Each transmitter has an individually assigned, unique ID code. In order to start opera-
tion, the receiver must be linked with the ID code of the transmitter to which it is being
paired. Once the link is made, the ID code is stored in the receiver and no further link-
ing is necessary unless the receiver needs to be used with another transmitter.
Link procedure
1
Bring the transmitter and the receiver close to each other,
within 20 inches (half meter).
2
Turn on the transmitter.
3
Turn on the receiver.
4
Push the tactile switch of the receiver.
When the link is complete, the LED in the receiver changes
to solid green.
Precaution:
If there are many Futaba S-FHSS/FHSS systems turned on in close proximity to the R2104GF, your
receiver might not link to your transmitter. In this case, even if the receiver's LED stays solid green, un-
fortunately the receiver might have established a link to one of other transmitters. This is very dangerous
if you do not notice this situation. In order to avoid the problem, we strongly recommend you to double-
check whether your receiver is really under control by your transmitter by giving the stick input and then
checking the servo response.
*Please refer to the table below for LED status vs receiver's condition.
LED status vs receiver's condition:
No signal reception
Receiving signals
Receiving signals, but ID is unmatched.
*1: LED could be change to red during intermittently during data processing.
Warning
After the linking is done, please cycle receiver power and check if the receiver to be linked is re-
ally under the control of your transmitter.
Do not perform the linking procedure with motor's main wire connected or the engine operating
as it may result in serious injury.
Tactile switch/LED

Connectors

4 :CH4 servo(CH4)
3 :CH3 servo(CH3)
2 :Throttle servo(CH2)
1 :Steering servo(CH1)
B :Power connector
Red : On
Green: On
*1
Green: Blink
23