Troubleshooting - FUTABA 2PL-2.4GHZ Instruction Manual

If your system fails to operate or you experience a short range problem or erratic control,
check the table below for possible causes. If after you have followed the suggestions
listed the problem is not corrected, return the system to our service department for
inspection and repair.
Battery
Dead battery
Batteries inserted incorrectly.
polarity markings
Faulty contact
contact
Dirty contacts
Battery
Dead battery
Wrong polarity
Antenna
Near other wiring
Was antenna cut
Is the antenna installed correctly
Monitor LED
Check the LED of the receiver.
Refer to the "How to link the transmitter and the receiver".
Wiring incorrect
Loose connections
Binding or loose
Is movement stiff
Noise problems

Troubleshooting

(Item Check)
Transmitter
Change the batteries.
Reload the batteries in accordance with the
Check to see if the contacts are bent and not making good
Clean the contacts and check for corrosion.
Receiver
Replace or recharge
Check connections
Move away from wiring
Request repair
Connector connections
Insert all connectors firmly
Push the connector in firmly
Linkage
Adjust the linkage in model
Adjust linkage in model
Motor (Electric powered)
Install capacitors on motor
Refer to the receiver installation.
Reference
23