Larson Electronics EPL-HB-175LED-RT-WLM Instruction Manual

175W Explosion Proof High Bay LED Light Fixture
Paint Spray Booth Approved - 25,000 Lumens - T5
This explosion proof light is designed for illumination of industrial locations. It uses the latest in
solid state lighting technology for long life, low maintenance and high efficiency.
The unique design focuses the light where it is needed, giving improved efficiency over a
conventional HID luminaire.
An internal, universal input, power-factor-corrected switch-mode supply allows it to be used from any
nominal 100-277V AC 50/60 Hz or 11-25 Volts AC/DC power supply (depending on model) without
any variation in light output.
WARNING
To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected
and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
•
Be certain electrical power is OFF before and during installation and maintenance.
•
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
•
Make sure the supply voltage is within the luminaires' voltage rating.
•
Ensure the marked T rating is less than the ignition temperature of the Hazardous
Atmosphere.
•
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
For supply connections, use wire rated for at least 110°C
Recommended mounting height is 25-65 feet.
MOUNTING
The EPL-HB-175LED-RT-WLM comes standard with a wall-mount configuration. This mounting
component extends the fixture up to 6" from a flat, vertical mounting surface. Spacing between the
mounting component and LED fixture`s fins, which are located at the back of the unit, streamline cool
operation. This wall-mounting solution is ideal for illumination directly above busy sections of
facilities, work areas, doorways and more. Additionally, the mounting configuration can facilitate
accurate light placement over control stations, switchboards, panels and segregated sections of work
sites.
Larson Electronics, LLC
Instruction Manual
Phone: (800) 369-6671 Fax: (903) 498-3364
EPL-HB-175LED-RT-WLM
www.larsonelectronics.com 1 of 2