Larson Electronics EPL-HB-100LED-RT-CM Instruction Manual

100w explosion proof high bay led light fixture 14,000 lumens - paint spray booth approved

Advertisement

100W Explosion Proof High Bay LED Light Fixture
14,000 Lumens - Paint Spray Booth Approved
This explosion proof light is designed for illumination of industrial locations. It uses the latest in
solid state lighting technology for long life, low maintenance and high efficiency.
The unique design focuses the light where it is needed, giving improved efficiency over a
conventional HID luminaire.
This light fixture is shipped preconfigured to work in the selected voltage range. This includes
100-277V AC 50/60hz or 11-25V AC/DC depending on model selected. An internal, universal input
power-factor-corrected switch allows it to be used from any voltage within range without variation in
light output. Check product label for correct input voltage!
WARNING
To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected
and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
Be certain electrical power is OFF before and during installation and maintenance.
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
Make sure the supply voltage is within the luminaires' voltage rating.
Ensure the marked T rating is less than the ignition temperature of the Hazardous
Atmosphere.
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
For supply connections, use wire rated for at least 110°C
Recommended mounting height is 15-40 feet.

MOUNTING

This fixture features a ceiling mounted junction box with mounting tabs, allowing the fixture to be
mounted to any flat surface that is capable of supporting the load, and where holes can be
drilled for the mounting hardware. Wiring is accessed through the 3/4'' NPT hubs on the junction
box. See wiring diagram below for completing connections.
Larson Electronics, LLC
Instruction Manual
Phone: (800) 369-6671
Fax: (903) 498-3364
EPL-HB-100LED-RT-CM
www.larsonelectronics.com
1 of 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EPL-HB-100LED-RT-CM and is the answer not in the manual?

Questions and answers

Summary of Contents for Larson Electronics EPL-HB-100LED-RT-CM

  • Page 1 Wiring is accessed through the 3/4'' NPT hubs on the junction box. See wiring diagram below for completing connections. Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com...
  • Page 2 4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated. Should further information not covered by these instructions be required, please contact Larson Electronics at 1-800-369-6671 or sales@larsonelectronics.com for further assistance. Please visit LarsonElectronics.com for Warranty and Return information.

Table of Contents