Related Manuals for Feider Machines FHFCA18L-1
Summary of Contents for Feider Machines FHFCA18L-1
- Page 1 Original Instructions Vacuum FHFCA18L -1 BUILDER SAS 32 Rue Aristide Bergès, 31270 CUGNAUX - FRANCE...
- Page 4 “Caution - Read the operating instructions to reduce the risk of inquiry” Wait at least 24 hours before vacuuming an oven or a fireplace in order to be sure that the fire has gone out and the ash has cooled down.
- Page 5 Important! When using the appliance, a few safety precautions must be observed to avoid injuries and damage. Please read the complete operating instructions with due care. Keep this manual in a safe place, so that the information is available at all times. If you give the appliance to any other person, hand over these operating instructions as well.
- Page 6 harmful to health. Store the appliance in a dry indoor location. Never use the appliance if it is damaged. Only allow the appliance to be serviced by an authorized customer service center. Only use the appliance to carry out work for which has been designed.
-
Page 7: Battery And Charger Safety
After and before vacuum cleaning, empty and clean the tank in order to prevent the accumulation of materials which could present a fire hazard in the vacuum cleaner. Appliance is only to be used with the power supply unit provided with the appliance. - Page 8 The battery pack is not fully charged out of the carton. First read the safety instructions and then follow the charging notes and procedures. In heavy use the battery pack will become warm. Allow the battery pack to cool to room temperature before commencing with the charging.
- Page 9 7 Suction tube 8 Flexible hose 9 Cartridge filter 10 Charger 11 Battery pack 12 Push lock button 13 Suction hose holder 4. Intended use The ash vacuum cleaner is suitable for vacuuming cold ash or cold material residues from fireplaces, charcoal ovens, ash-trays or barbecues.
- Page 10 Fitting the appliance head (Fig. 3) The appliance head (3) is fastened to the container (5) by the locking hook (4). To remove the appliance head (3), open the locking hook (4) and remove the appliance head (3). When fitting the appliance head (3), make sure that the locking hook (4) locks into place correctly.
- Page 11 begin to Green flash light. You will find a label with “Charger indicator” of the LED indicator on the charger. The battery pack can become a little warm during the charging. This is normal. If the battery pack fails to charge, check: ...
- Page 12 Battery pack is full of charge. Charging is finished and battery pack in the charger. The temperature of battery is too high or too low, the charger is under protection status. The charging function can be recovered after the temperature is normal. Unrecoverable battery malfunction.
-
Page 13: Troubleshooting
8.3 Cleaning the container (5) The container can be cleaned with a damp cloth and some soft soap or under running water, depending on the amount of dirt. 8.4 Cleaning the filter (9) Clean the cartridge filter (9) , e.g. by tapping and brushing or by blowing out with compressed air at low pressure. - Page 14 or not, The battery temperature before commencing with the protection system will not charging. allow the battery to be charged if the battery temperature is over 40℃ after use. 11. Disposal and recycling For EU countries only Never place any electric power tools in your household refuse. To comply with European Directive 2012/19/EU concerning old electric and electronic...
Need help?
Do you have a question about the FHFCA18L-1 and is the answer not in the manual?
Questions and answers