Before reading this manual This is a basic installation manual for use of an IDIS network camera. Users who are using this product for the first time, as well as users with experience using comparable products, must read this operation manual carefully before use and heed to the warnings and precautions contained herein while using the product.
Before reading this manual Safety Precautions WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Important Safeguards 1.
IDIS Co., Ltd. reserves all rights concerning this operation manual. Use or duplication of this operation manual in part or whole without the prior consent of IDIS Co., Ltd. is strictly prohibited. Contents of this operation manual are subject to change without prior notice for reasons such as functionality enhancements.
• Quick and easy firmware upgrade over the network live video or scan recorded video using a web browser. • Redundant firmware and auto recovery features for In addition, you can use the IDIS Center to manage improved system stability network cameras and view/record video.
Part 1 – Introduction Accessories Upon purchasing the product, check inside the box to make sure all the following accessories are included. Network Camera Screws and Anchors (each 3ea.) Desiccant, double-sided tape Allen Wrench Quick Guide Terminal Blocks (2 ea.) Protect Connector Safety Wire Screw...
Part 1 – Introduction Overview Body Dome Cover IR LED Lens Factory Reset Button Lever Anti-Reflection Bushing Camera Body Installation Bracket Power Network Port Wall/Ceiling Installation Hole Alarm I/O, Audio I/O SD Memory Card Slot Cable Rubber Pipe Cover...
Page 9
For more information on network connection setup, - I (In): Connect an alarm-in device to this port. refer to the IDIS Discovery operation manual. (Mechanism: Choose between an NC (Normally Closed) type or an NO (Normally Open) type) →...
It's also possible to do a factory reset by pressing and releasing the reset button while the camera is turned on or using the IDIS Discovery program from a remote location. A factory reset will reboot the system. For more information on factory reset, refer to the IDIS Discovery operation manual.
Part 1 – Introduction Lens Remove the dome cover. Motorized focus and zoom lens When installing or handling the camera, be careful not to give an impact on the lens to prevent a malfunction from occurring. Installation Pull the lever and rotate the camera body counterclockwise to separate it from the installation Installation of this product does not require the use of bracket.
Part 1 – Introduction Inserting a SD Memory Card Installation Insert a SD memory card into the SD memory card slot • Check the wall or ceiling to see if it needs to be with the 'micro SD' print facing upward. reinforced.
Page 13
Part 1 – Introduction (If necessary) Attach one end of the safety wire (not provided) to the wall or ceiling, and the other end of the safety wire to the installation location on the 3/4” Conduit Pipe installation bracket. Safety Wire Hole Make the network cable go through the cable rubber using the protect connector.
Page 14
Part 1 – Introduction Pull the cable slightly and arrange the rubber as shown below. Desiccant If you insert a thin cable or more than two cables, it Fold in half is advised to finish by using silicon to make sure to perfectly waterproof it.
Part 1 – Introduction Closing the Dome Cover Connect external devices, the network cable, and the power adapter. Fasten the screws for the dome cover clockwise using Adjust the angle. For more information, refer to the the Allen wrench provided with the camera. Angle Adjustment.
Part 2 - Camera Connection Use the camera by connecting to DirectIP® NVR or non DirectIP® NVR, VMS such as IDIS Center. With DirectIP® NVR-based Layout Audio In Audio Out Alarm Out Power Alarm In Network Camera Monitor Out Power...
Control the camera over the network from software installed on a computer. Ideal for using the camera over the network from a remote location. The contents in the camera operation manual are only for users using the camera with non DirectIP® NVR connection or VMS connection such as IDIS Center.
ID and password as a safety precaution. camera. Unable to launch IDIS Web. If the IDIS Web login screen is not loading, check which version of Microsoft Internet Explorer you are using. IDIS Web may not launch properly on versions 10 or below.
Part 3 - Appendix Specifications These product specifications may change without prior notice. Video Image Sensor 1/1.8" CMOS Max. Resolution DC-D6831WRA 3840 x 2160 DC-D6631WRA 3328 x 1872 Scanning Mode Progressive Scan Lens type Motorized Vari-focal Focal Length f=4.3mm~9.8mm Aperture F1.6~F2.6...
Page 21
Part 3 - Appendix Edge Storage* (Optional) (Micro SD/SDHC/SDXC memory card (class 6 or higher, max. 512GB)) * An SLC (Single Level Cell) or MLC (Multi Level Cell) card by SanDisk or Transcend is recommended to ensure stable recording performance. * An SD memory card is a consumable product with a finite service life.
Page 22
IDIS Co., Ltd. For more information, please visit at www.idisglobal.com...
Need help?
Do you have a question about the DC-D6831WRA and is the answer not in the manual?
Questions and answers