Mounting The Access Point On A Horizontal Surface - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual

Mounting the Access Point on a Horizontal Surface

Mounting the Access Point on a Horizontal Surface

Caution Avoid mounting the access point on a wall or vertical surface because the metal plate on the unit
designed to dissapate heat acts as a reflector, causing the access point's integrated antenna to propagate
directionally. The directional propagation can result in reduced performance, especially when using
advanced features such as voice or location.
You will need to supply the appropriate wall anchors and fasteners to mount your access point. Follow
these steps to mount the access point on a horizontal surface:
Use the mounting plate as a template to mark the locations of the two mounting holes (labled with an X)
Step 1
and the location of the cable access hole (see
Figure 2-6
2
3
2
1
2
3
4
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-12
Mounting Plate
1
B
C C
A
X
B
C
C
A
4
3
X
1
Keyhole clip
Screw holes (A, B, C)
Screw hole (X)
Location for cable access hole
Figure 2-6).
B
2
A
5
B
2
A
6
7
5 T-bar hanger clip hole
6
Security screw hole
7
Padlock hole
Chapter 2 Installing the Access Point
OL-8369-05