Chapter 2 Installing The Acces Point; Safety Information; Fcc Safety Compliance Statement; General Safety Guidelines - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual

Hardware installation guide
Hide thumbs Also See for 1130AG - Aironet - Wireless Access Point:
Table of Contents

Advertisement

Safety Information

Safety Information

Follow the guidelines in this section to ensure proper operation and safe use of the access point.

FCC Safety Compliance Statement

The FCC with its action in ET Docket 96-8 has adopted a safety standard for human exposure to radio
frequency (RF) electromagnetic energy emitted by FCC certified equipment. When used with approved
Cisco Aironet antennas, Cisco Aironet products meet the uncontrolled environmental limits found in
OET-65 and ANSI C95.1, 1991. Proper installation of this radio according to the instructions found in
this manual will result in user exposure that is substantially below the FCC recommended limits.

General Safety Guidelines

Warnings

Translated versions of the following safety warnings are provided in

Warnings."

Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning
Read the installation instructions before you connect the system to its power source. Statement 1004
This product must be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source or an
Warning
IEC60950 compliant limited power source. Statement 353
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
the protective device is rated not greater than:
20A Statement 1005
Do not operate your wireless network device near unshielded blasting caps or in an explosive
Warning
environment unless the device has been modified to be especially qualified for such use.
Statement 245B
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-2
Do not hold any component containing a radio so that the antenna is very close to or touching any
exposed parts of the body, especially the face or eyes, while transmitting.
Chapter 2
Installing the Access Point
Appendix A, "Translated Safety
OL-8369-05

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents