Table of Contents
Advertisement
Features
Electric circuit diagram
Features
1.Home water heater:
Collector equipment is aslant installed on the rooftop and perfectly integrated
with building, match the building standard and fashion nowadays.
2.
tube is efficient and reliable:
Vacuum glass
The conductive efficiency of the tube is supernale. Vacuum tube of collector
equipment is without water and dirts, antifreeze, high endurance, efficient and
secure.
3.Selective coat endothermic system
The endothermic system adopts the latest international high-tech. It is
characterized by high absorbing capacity and low reflectivity.
4.Heat water system of enduring pressure:
Water can be supplied in more than one line. The flux of water is enough to use,
the usage of water is comfortable and the regulation of water temperature is
convenient. System run reliably and can be used under all-weather .
5
.scientific designing:
Four kinds of working modes are designed to supply water under different
season.Control the running of pump automatically according to different
temperature , enconomizing energy and prolonging life of pump. Possess the
function of digital display of water temperature and multisafeguard, safe to
use,easy to use.
Electric circuit diagram
C o n t r o l l e r
Display Board
L
K1
E
K2
N
Controller
Wire Board
RT1
RT2
L:
Brown Wire
N:
Blue Wire
E:
YelloW/Green Wire
K1
K2
R
elay
EH:H
eating Element
MT:High
Temperature Limiter
Pump
RT1:T
ank Temperature Sensor
RT2:C
ollector Temperature Sensor
1
Notes for usage
the serving person.
8.When the system runs continually over one month, you are suggested to
check regularly whether the deviation of the clock is large so as to adjust the
clock promptly and ensure that the preset and intellectual heating modes
operate normally.
9.In cases when the power supply line of the appliance is damaged, it is the
personnel of after service who change that for specially designed lines
(provided by the manufacturer).
10.In cases when the temperature of water-storing tank exceeds 85 , and the
electrical enclosure indicates E2.First,you should cut off power supply,
then,to release a little of hot water and supply some cold water.when the
temperature of water is decrease and then to connect power supply ,the
fault is able to obviate.
11.The temperature difference for running of circulating water pump suggests
that the temperature should be chosen as 15
sunshine is strong(eg, summer), and 10
weak (eg, winter).
12.When water heater is not used for long and you use it again, to avoid
occurrence of accidents,you shoud exhaust the system, and the system must
be full of water before usage,let the gas which lie in the pipe out,meanwhile,
make sure there is no smoke, fire or other appliances near when you open
the valve,the exhausting way: open the hot water outlet and cold water inlet
valve, when the water come out sustaining after exhausting all the gas, then
close the hot water outlet valve. you had better operation the valve in the low
tempreture,such as wee hours or night, or the life of the system will be
influenced. to check all the parts of the system in good condition, and make
sure the tank full of water, then you can use it.
13.Operation exhaust valve termly so as to clear dirty thing, and insured to
exhaust valve be not block off.
in seasons when the
in seasons when the sunshine is
14
Advertisement
Table of Contents
