Installation Points Of Attention; Installation Method - Haier FCD-HM50 Operation Instruction Manual

Installation Points of Attention · Installation Method

Installation Points of Attention

Reserve a certain space during the installation of water heater to facilitate future maintenance. If the water
heater is inlaid in the pinch plate during installation period, the pinch plate at right side should be removable
to facilitate the dismantlement of the plastic cover for future maintenance.
Ensure the inlet pressure of tap water is not less than 0.05MPa, and the maximum pressure is 0.75MPa.
The electric water heater shall be installed indoors where the ambient temperature is over 0℃, and the
pipeline should be laid out correctly. The distance between the outlet of hot water and using point of hot water
should not be too far. If this distance is over 8m, heat preservation treatment should be made on hot water
pipeline to reduce the loss of heat.
The wall to mount the water heater should be solid and secure, and it should be able to bear two times the
weight of the water heater filled with water. If it is a non-load bearing wall or a hollow-brick wall, take the
corresponding protection measures such as additional installation of a bracket, use of wall screw, or
installation of backing plate.
The installation position of the electric water heater shall be chosen at places where is convenient for
operation, maintenance and there is a floor drain. If the water tank or water tube leaks, it should not cause
damage to the surroundings or underside facilities. The installation position should not be in the proximity of
a closet, bathtub, washing basin, and door frame, which may produce a depressing or unsafe feeling in the
user.
Don't connect the inlet & outlet tubes inversely. The safety valve should be installed at the designated
position, and it may not be changed willfully. The exhaust pipe should reach outside and not be blocked.
Note: Due to the increased power of this kind of electric water heater, it is suggested that you should use a
power socket matching the plug of this unit (16A) during installation in order to ensure the normal working of
this unit and safety of your home.

Installation Method

The installation shall be made by the installation
staff belonging to the after-sales service department
Fig 1
of our company or the designated installation staff.
The water heater adopts wall-mounted type
installation.
Volume
6