Safety Points Of Attention - Haier FCD-HM50 Operation Instruction Manual

Safety Points of Attention

Check if ammeter and
wires are in
conformity with rated
current of the water
heater. Request a
qualified electrician to
check if necessary.
Don't use electric
apparatuses if the
wire is damaged and
the power socket and
plug slack,
otherwise, it may
cause such accidents as electric shock, short
circuit or fire. Please confirm if the power plug
is closed connected with the power socket.
After installation and
before the first use,
firstly fill with water
and then connect the
power. If the power is
connected under the condition that the vessel is
not fully filled with water, the heating tube will
overheat, which may result in an accident.
Operation by a child should be supervised by an
adult.
In cold areas, if this
unit is not to be used
for a long time in
winter, please lift the
handle of the safety
valve and drain out
the water to prevent the water heater from being
damaged due to water freezing.
The water temperature value indicated in the display screen is the water temperature around the detection
points. The outlet temperature of the water heater is normally higher than the temperature indicated in display
screen. Prior to use, you should drain the cold water first and then adjust the water temperature value you desire
to avoid scalding. During operation, the water temperature value indicated in the display screen is also the water
temperature around the detection points, is not the actual outlet temperature, and please don't directly drain the
hot water.
The design of this unit adopts the "Shockproof Wall" patent technology of our company. In the normal situation
that it is connected with civil electricity, this unit will also effectively ensure your operation safety through the
technology filter of "shockproof wall" of this unit, even the in occurrence of deteriorated that exterior is
mistakenly connected to the civil electricity with earth wire that will result in a live earth wire. When you
perceive that there is a sensitive current, please remove the power plug, and immediately notify the after-sales
service department of our company for maintenance. Don't dismantle this unit by yourself.
Don't operate! If it is mistakenly used, it may result in bodily injury.
You must follow the instruction to operate this unit. If it is mistakenly used, it may result in bodily injury or
property loss.
This water heater uses
AC 220V/50Hz
power. It uses an
independent socket (it
is prohibited to use a
multipurpose socket), and conducts reliable
earthing, and the socket quality must meet the
national standards. Remove the metal sheet on
power plug to prevent fire accidents arising due to
stains on the metal sheet.
The power socket of
the water heater must
be installed in a dry
place
cannot spray it. Don't
insert and remove the
power plug with wet hands, otherwise, such
accidents as electric shock and injury may occur.
Please don't point the
shower nozzle at the
body when turning the
water
injury from scalding.
If the power wire of
the electric water
heater is damaged, it
must be replaced
with a special wire
(provided
serviceman. No one is allowed to conduct the
dismantlement, except for professional technical
serviceman. In addition, don't place flammable
objects near water heater.
Symbols Description
3
where water
on to prevent
by manufacturer) by after-sales