Elatec TWN4 MultiTech 2 M LF HF Integration Manual
Hide thumbs
Also See for TWN4 MultiTech 2 M LF HF:
- User manual (60 pages) ,
- Manual (30 pages) ,
- Technical handbook (21 pages)
Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Elatec TWN4 MultiTech 2 M LF HF
Summary of Contents for Elatec TWN4 MultiTech 2 M LF HF
- Page 1 TWN4 MultiTech 2 M LF HF INTEGRATION MANUAL...
-
Page 2: Table Of Contents
TABLE OF CONTENTS INTRODUCTION ................................3 ABOUT THIS MANUAL ............................3 ELATEC SUPPORT ..............................3 SAFETY INFORMATION ............................4 INTEGRATION INSTRUCTIONS ..........................6 GENERAL ................................... 6 LIST OF APPLICABLE RULES..........................6 SPECIFIC OPERATIONAL USE CONDITIONS ..................... 6 LIMITED MODULE PROCEDURES ........................6 TRACE ANTENNA DESIGN .......................... -
Page 4: Introduction
In case of any technical questions or product malfunction, refer to the ELATEC website (www.elatec.com) or contact ELATEC technical support at support-rfid@elatec.com © 2024 – ELATEC GmbH – TWN4 MultiTech 2 M LF HF – integration manual – DocRev09 – EN – 05/2024 Page 3 of 14... -
Page 5: Safety Information
Before installing the product into the host device, the power supply of the host device must be turned off. © 2024 – ELATEC GmbH – TWN4 MultiTech 2 M LF HF – integration manual – DocRev09 – EN – 05/2024 Page 4 of 14... - Page 6 Any failure to comply with the safety information given in this document is considered improper use. ELATEC excludes any liability in case of improper use or faulty product installation. © 2024 – ELATEC GmbH – TWN4 MultiTech 2 M LF HF – integration manual – DocRev09 – EN – 05/2024 Page 5 of 14...
-
Page 7: Integration Instructions
3 INTEGRATION INSTRUCTIONS GENERAL TWN4 MultiTech 2 M LF HF may be installed into any host device, as long as it is operated under the operational conditions stated in the product user manual and other technical documents (e.g. data sheet). The product is equipped with two integrated RFID antennas. Thus, no antenna installation is required. -
Page 8: Antennas
TWN4 MultiTech 2 M LF HF can be fixed into the host device with four screws M2.5. Observe the minimum separation distance recommended by ELATEC when the host device already contains other © 2024 – ELATEC GmbH – TWN4 MultiTech 2 M LF HF – integration manual – DocRev09 – EN – 05/2024 Page 4 of 14... -
Page 9: Electrical Connection
3.13 PROGRAMMATION/SOFTWARE INTEGRATION Hirose DF11 series, 2mm pitch or type equivalent. In case the reader module is not connected with a cable delivered by ELATEC, the reader module can only be connected with a cable equipped with the following connector: Manufacturer: Shenzhen Le Qing Lin Hai Electronics Co., Ltd Part no.: A2002-H04X2... -
Page 10: Integrator And Host Requirements
This external label must contain the RAMATEL identification data of the approved product preceded by the legend “CONTIENE” (contains), for example: CONTIENE RAMATEL H-28225 © 2024 – ELATEC GmbH – TWN4 MultiTech 2 M LF HF – integration manual – DocRev09 – EN – 05/2024 Page 6 of 14... -
Page 11: Brazil
If additional filing is required, please contact the person at ELATEC GmbH responsible for certification of the RF module. © 2024 – ELATEC GmbH – TWN4 MultiTech 2 M LF HF – integration manual – DocRev09 – EN – 05/2024 Page 7 of 14... -
Page 12: Appendix
Title 47 of the Code of Federal Federal Communications FCC’s rules and regulations Regulations (CFR) Commission © 2024 – ELATEC GmbH – TWN4 MultiTech 2 M LF HF – integration manual – DocRev09 – EN – 05/2024 Page 8 of 14... -
Page 13: B - Terms And Abbreviations
01/2022 “Compliance Statements” updated Chapters “Safety Information” and “Compliance Statements” 07/2021 updated First edition 05/2021 © 2024 – ELATEC GmbH – TWN4 MultiTech 2 M LF HF – integration manual – DocRev09 – EN – 05/2024 Page 9 of 14... - Page 14 ELATEC reserves the right to change any information or data in this document without prior notice. ELATEC declines all responsibility for the use of this product with any other specification but the one mentioned above. Any additional requirement for a specific customer application has to be validated by the customer themselves at their own responsibility.
Need help?
Do you have a question about the TWN4 MultiTech 2 M LF HF and is the answer not in the manual?
Questions and answers