Teac CDW54E User Manual page 12

With S1 open (jumper not set) the TEAC CD-W54E ist set to sin-
gle or slave mode by setting the jumpers S2 and S3. The set mode
is irrespective of the CSEL signal. Master/slave mode is determined
by CSEL if S1 is shorted (jumper set). In this case S2 and S3 are
irrespective for setting the mode.
Note:
When setting modes using these straps, be sure to switch off the
CD-RW drive before doing so.
S1 S2
X
–
–
Remark:
4. Controls and Functions
S3 Remarks
CSEL. Master or Slave drive is set by using
CSEL terminal. (DASP signal is used to
– –
recognize slave drive. If slave is absent, the
shadow register is used.)
X – Slave
Master (DASP signal is used to recognize
– X
slave drive. If slave is absent, the shadow
register is used.).
X: Strap shorted
–: Strap open
35