On-Screen Menu Controls; Calling Up The Menu Display, Selecting An Item; Aspect Ratio (Picture Aspect Ratio Switching); Filter Select (Built-In Filter Selection) - JVC BM-H1310SU - Color Production Monitor Instructions Manual

ON-SCREEN MENU CONTROLS

By calling up the menu display on screen, various functions can be selected and set
as needed.

Calling up the menu display, selecting an item

1.
Press the MENU button to call up the menu display on screen (see 1 1 1 1 1
below). (Press again to make the display disappear.)
2.
Press the or
selected item.
3.
Press the or
4.
After selecting another item by pressing the
These settings are all kept in memory after power is turned off.
5.
Press the MENU button to complete. The menu display disappears.
ASPECT RAT I O
F I L TER SE LEC T
PEAK I NG FREQ.
PEAK I NG LEVEL
AFC
COLOR TEMP.
NTSC SETUP
COMPO. L E VE L
q MEMORY MODE
RGB / COMPO(SDI)
ENTER
1 1 1 1 1

ASPECT RATIO (picture aspect ratio switching)

The aspect ratio of the picture can be switched between 4:3 and 16:9.
When switching to "16-9" on screen, the height of the picture is slightly
reduced (see right).
Setting
4-3
16-9

FILTER SELECT (built-in filter selection)

When a composite video signal of the NTSC system (excluding NTSC
4.43) is input to the monitor, either or both of two filters in the monitor can
be activated.
Setting
COMB (comb filter)
BOTH (both filters)
NOTCH (Trap filter)
10
button to select an item to be set. "
button to change the setting.
q MENU r
:4-3
:COMB
:2.6MHZ
:0dB
:NORMAL
:6500
:7.5
:BETA75
r
:RGB AFC
:
Standard picture aspect ratio (4:3)
Displays the picture in 16:9 aspect ratio
Reduces colour noise in NTSC video signals for clearer pictures.
Both comb and trap filters function at the same time.
Eliminates dot interference that would show up in the vertical
boundary between two different colours.
" is indicated for the
or button, repeat step
AFC
:NORMAL
2 2 2 2 2
Function
Function
NOTE
When the menu display 1 1 1 1 1 (shown at
left below) is on screen, press the
ENTER button. The display changes
to 2 2 2 2 2 (shown below center). In this
state, you can also select the item or
change the setting.
When the display 2 2 2 2 2 is on screen,
each time the button is pressed
3
.
while the ENTER button pressed,
the indication moves up or down on
screen (the display 3 3 3 3 3 ). Press the
MENU button with display 2 2 2 2 2 or 3 3 3 3 3
on screen, and the display is
restored to 1 1 1 1 1 .
If no operation occurs for about 5
minutes after calling up the menu
display on screen, the display
disappears automatically.
:NORMAL
3 3 3 3 3
4:3
16:9
NOTE
The function can be operated and
the indication appears only when a
composite video signal of the NTSC
system (excluding NTSC 4.43) is
input to the monitor.