Advertisement
Connecting the unit
English
Connecting the power cord
This product
IP-BUS input
Antenna input
(Blue)
Fuse (10 A)
IP-BUS cable
Yellow
Connect to the constant 12 V supply terminal.
Orange/white
Fuse resistor
Connect to lighting switch terminal.
Red
Fuse resistor
Connect to terminal controlled by ignition switch (12 V DC).
Black (chassis ground)
Connect to a clean, paint-free metal location.
White
Gray
Front speaker
Front speaker
Left
White/black
Gray/black
Right
Green
Violet
Rear speaker or
Rear speaker or
Subwoofer (4 Ω)
Subwoofer (4 Ω)
Green/black
Violet/black
When using a subwoofer of 70 W (2 Ω), be sure to connect with Violet and Violet/black leads of this unit. Do not
connect anything to Green and Green/black leads.
Green
Violet
Subwoofer (4 Ω)
Not used.
× 2
Green/black
Violet/black
Connecting the unit
English
Microphone input
(MVH-P8300BT only)
Microphone
4 m (13 ft. 1 in.)
(MVH-P8300BT only)
Wired remote input
Hard-wired remote control adaptor can be connected
(sold separately).
Pioneer IP-BUS
accessories
(sold separately)
Connection method
1. Clamp the lead.
2. Clamp firmly with
needle-nosed pliers.
Note:
· The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking
Parking brake
brake. This lead must be connected to the power
Power supply side
switch
supply side of the parking brake switch.
Ground side
Blue/white
Connect to system control terminal of the power amp or
auto-antenna relay control terminal (max. 300 mA 12 V DC).
With a 2 speaker system, do not connect anything to the speaker leads
that are not connected to speakers.
Note:
· Change the initial setting of this unit (refer
to the Operation Manual). The subwoofer
output of this unit is monaural.
Connecting the unit
English
When connecting to separately sold power amp
Rear output
Power amp
This product
(sold separately)
To rear output
Power amp
(sold separately)
To front output
Power amp
Front output
(sold separately)
Subwoofer output
To subwoofer
output
Connect with RCA cables
(sold separately)
System remote control
Blue/white
Connect to system control terminal of the
power amp or auto-antenna relay control
terminal (max. 300 mA 12 V DC).
Left
Right
Subwoofer
Subwoofer
Front speaker
Front speaker
Rear speaker
Rear speaker
Perform these connections when
using the optional amplifier.
Advertisement
