Page 2
Complete and mail the enclosed (RGA) prior to returning the defective box and packaging. Quorum will not bear warranty card within 10 days to ensure unit or part. Call (817) 626-5483 - responsibility for any shipping damage.
Page 3
1. SAFETY RULES Model #22523-xx: 14.13 lbs 10. Do not attempt to control the operation 1. To avoid possible electric shock, turn 5. The outlet box and ceiling support of the fan (or an optional light kit) from off the electricity at the main fuse box or joist used must be securely mounted, and any wall control that is not approved by circuit panel before you begin the fan...
Page 4
3. MOUNTING OPTIONS 1. Disconnect the power by removing fuses WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, FIRE, OR PERSONAL INJURY, or turning off circuit breakers. MOUNT THE FAN ONLY TO AN OUTLET MARKED ACCEPTABLE FOR FAN SUPPORT AND USE MOUNTING SCREWS PROVIDED WITH THE OUTLET BOX.
Page 5
4. HANGING YOUR FAN Fig. 4 Fig. 5 WARNING - Turn off the power! DO NOT fasten the blades to the fan until it is assembled and hanging from the ceiling. Hugger/ Outlet box mounting To do so now will likely bend the blade arms plate and almost certainly cause wobble.
Page 6
Use ONLY wall controls approved wire from the fan is on the other side. upwards and push them carefully up into by Quorum. Use of unapproved wall the outlet box through the center hole in controls will cause unacceptable 2. Connect the green ground wires from the mounting plate.
Page 7
6. COMPLETING INSTALLATION Fig. 8 Fig. 10 1. Make sure the wiring is safely inside the outlet box as instructed in Step 5 - Electrical Connections. Remove two of Hugger/ Mounting the four hugger/mounting plate screws mounting ring plate from the mounting plate and keep, then loosen the other two screws.
Page 8
7. FAN OPERATION AND CARE 1. A ceiling fan is an environmentally 3. Clean you fan periodically using only Fig. 14 smart choice to cool as well as to help a cloth dampened with a mild detergent warm your home or office. Adjust your solution for all hardware - never use solvents.
Page 9
8. TROUBLESHOOTING FAN WILL NOT START 3. Use of a standard light rheostat or an EXCESSIVE WOBBLE 1. Check that the electricity has been unapproved fan wall control to control the NOTE: A small amount of wobble is turned on at the circuit breaker which had fan speed will always cause an annoying considered acceptable and should not be probably been turned off during installation.
Need help?
Do you have a question about the MAIN STREET Banzai 52" and is the answer not in the manual?
Questions and answers