Quorum MAIN STREET Aerovon Installation Instructions Manual

Quorum MAIN STREET Aerovon Installation Instructions Manual

Advertisement

Quick Links

THE AEROVON CEILING FAN
INSTALLATION INSTRUCTIONS
Please read and save these instructions
SUITABLE FOR INDUSTRIAL USE
MAIN STREET
These instructions are to be used in
the installation of the following
quorum
QUORUM INTERNATIONAL fans...
by
The Aerovon 52" & 60"
© 2021 quorum All Rights Reserved.
P.O. Box 961008 • Fort Worth, TX 76161 • (817) 626-5483 • FAX (817) 626-5540
I0320-12/21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MAIN STREET Aerovon and is the answer not in the manual?

Questions and answers

Summary of Contents for Quorum MAIN STREET Aerovon

  • Page 1 These instructions are to be used in the installation of the following quorum QUORUM INTERNATIONAL fans... The Aerovon 52" & 60" © 2021 quorum All Rights Reserved. P.O. Box 961008 • Fort Worth, TX 76161 • (817) 626-5483 • FAX (817) 626-5540 I0320-12/21...
  • Page 2: Warranty & Service

    Complete and mail the enclosed (RGA) prior to returning the defective box and packaging. Quorum will not bear warranty card within 10 days to ensure unit or part. Call (817) 626-5483 - responsibility for any shipping damage.
  • Page 3: Safety Rules

    9. Wall switch. 2 mounting screws and 3 wire nuts, Wall plate w/2 mounting screws and 2 machine screws (j) 10. Blade balancing kit (k) IF YOU FIND THAT PARTS ARE MISSING. CONTACT YOUR DEALER FOR REPLACEMENT, OR CALL QUORUM DIRECTLY AND WE WILL MAIL REPLACEMENTS TO YOU IMMEDIATELY.
  • Page 4: Mounting Options

    3. MOUNTING OPTIONS 1. Disconnect the power by removing fuses WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, FIRE, OR PERSONAL INJURY, or turning off circuit breakers. MOUNT THE FAN ONLY TO AN OUTLET MARKED ACCEPTABLE FOR FAN SUPPORT AND USE MOUNTING SCREWS PROVIDED WITH THE OUTLET BOX.
  • Page 5: Hanging Your Fan

    4. HANGING YOUR FAN WARNING -Turn off the power! Fig. 5 Fig. 8 1. (Fig. 5) Remove the motor top housing and metal washer by remove the six screws with lock washers from the motor collar. Screws Metal washer 2. (Fig. 6) Insert the blade through the slot in motor housing.
  • Page 6: Electrical Connections

    Use ONLY wall controls approved by wires for use with an extended ball (green or bare copper), connect the wall Quorum. Use of unapproved wall /downrod assembly. If using the 4 in. or 6 control's ground wire to it. Otherwise, controls will cause unacceptable in.
  • Page 7 6. COMPLETING INSTALLATION 1. Make sure the wiring is safely inside the Fig. 12 outlet box as instructed in Step 5 - Electrical Connections. To install the Outlet box canopy, slide the canopy up to hanger bracket and place the key hole on the Hanger canopy over the screw on the hanger bracket...
  • Page 8: Troubleshooting

    8. TROUBLESHOOTING FAN WILL NOT START 3. Use of a standard light rheostat or an EXCESSIVE WOBBLE 1. Check that the electricity has been unapproved fan wall control to control the Note: A small amount of wobble is turned on at the circuit breaker which had fan speed will always cause an annoying considered acceptable and should not be probably been turned off during...

Table of Contents