Tektronix TG700 Instructions Manual
Tv signal generator platform rfi filter replacement
Hide thumbs
Also See for TG700:
- Service manual (810 pages) ,
- User manual (355 pages) ,
- Technical reference (224 pages)
Advertisement
Quick Links
Instructions
050-A025-52 and Above
TG700 TV Signal Generator Platform
RFI Filter Replacement
075-A014-51
Warning
The servicing instructions are for use by qualified
personnel only. To avoid personal injury, do not
perform any servicing unless you are qualified to
do so. Refer to all safety summaries prior to
performing service.
www.tektronix.com
*P075A01451*
075A01451
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Tektronix TG700
Summary of Contents for Tektronix TG700
- Page 1 Instructions 050-A025-52 and Above TG700 TV Signal Generator Platform RFI Filter Replacement 075-A014-51 Warning The servicing instructions are for use by qualified personnel only. To avoid personal injury, do not perform any servicing unless you are qualified to do so. Refer to all safety summaries prior to performing service.
- Page 2 Copyright © Tektronix. All rights reserved. Licensed software products are owned by Tektronix or its subsidiaries or suppliers, and are protected by national copyright laws and international treaty provisions. Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supercedes that in all previously published material.
- Page 3 Kit Description This kit provides parts and instructions to replace the RFI filter of your TG700 TV Signal Generator Platform. This document supports Tektronix modifications: BV4401, 443, 1666, and ECR30604. Products TG700 J310xxx and below Minimum Tool and Equipment List...
- Page 4 Kit Description TG700 RFI Filter Replacement Instructions...
- Page 5 Replacing the RFI Filter Perform the following procedure to replace the RFI filter: 1. Set the TG700 so its bottom is down on the work surface and its rear is Removing the Power Supply Module facing you.
- Page 6 11. Use a 7 mm nut driver to remove the nut securing the ground lead to the chassis. See Figure 1. 12. Use a screwdriver with a #2 Phillips tip to remove the two screw securing the RFI filter to the chassis. See Figure 1. 13. Pull the RFI filter away. TG700 RFI Filter Replacement Instructions...
- Page 7 23. Use a screwdriver with a #1 Phillips tip to tighten the two screws securing the power supply module to the mainframe. g End of document g TG700 RFI Filter Replacement Instructions...
Need help?
Do you have a question about the TG700 and is the answer not in the manual?
Questions and answers