Subscribe to Our Youtube Channel
Related Manuals for Lionel Plug-Expand-Play Sgt Stumpy's Red White & Boom Fireworks
Summary of Contents for Lionel Plug-Expand-Play Sgt Stumpy's Red White & Boom Fireworks
- Page 1 20129030250 9/21 Lionel Lionel Plug-Expand-Play ® Plug-Expand-Play ® Sgt Stumpy's Sgt Stumpy's Red White & Boom Fireworks Red White & Boom Fireworks Owner’s Manual Owner’s Manual...
- Page 2 SC-2 wiring and operation ASC and ASC 2 wiring and operation Replacing the LEDs Lionel Limited Warranty Policy & Service The following Lionel marks are used throughout this Owner’s Manual and are protected under law. All rights reserved. Lionel , FasTrack...
- Page 3 Accessory operation Control box is required for Note! operation of this accessory. Connector for control box Connector for power Connector for Connector for power control box UNDERSIDE OF ACCESSORY Figure 1. Installing the accessory...
- Page 4 Control box operation When power is applied, the fiber optics fireworks will be off. After 5 seconds, audio will start and the fiber optics sequence will begin in sync with the SOUNDS SMOKE audio. Sequence will replay every 60 seconds in this mode.
- Page 5 Note! For best results, we recommend you use only Lionel Premium Smoke Fluid (6-83280) in your smoke unit. Note! Overfilling the smoke reservoir will cause permanent damage to your accessory that may void the warranty.
- Page 6 Putting Smoke Fluid in the Smoke Unit continued Smoke switch UNDERSIDE OF ACCESSORY Figure 5. Smoke High-Low switch...
- Page 7 Wiring your accessory to a Plug-Expand-Play lock-on our Plug-Expand-Play accessory connects to either a Plug-Expand-Play lock-on (6-81313) or a Plug-Expand-Play power block lock-on (6-81314) with the 3-pin male connector that is attached to its base. Simply plug this connector into the lock-on and apply track power. To turn the accessory OFF, unplug the 3-pin connector from the lock-on or turn off the track power.
- Page 8 Connecting your accessory to FasTrack and tubular track ou are able to connect your accessory to FasTrack using an 8" 3-pin female pigtail (available separately, 6-82038). Plug in the 3-pin male connector from the accessory into the 3-pin female pigtail. Then attach the red wire to the inside rail and the black wire to the outside rail.
- Page 9 Connecting your accessory to a transformer o power your accessory using a CW-80 Transformer (6-14198)or any other power supply, you will need an 8" 3-pin female pigtail (available separately, 6-82038) to connect to the transformer terminals. Make sure that all connections are secure. Loose connections can produce extremely high temperatures.
- Page 10 Wiring for TMCC or LEGACY o power your accessory in the Command Control and LEGACY environments, you will need an SC-2 (6-22980), an ASC (6-14182), or an ASC2 (6-81639). You will also need an 8" 3-pin female pigtail (available separately, 6-82038) and a transformer (6-14198). See figures 9 and 10 for wiring.
- Page 11 LEDs that are expected to last for the life of the accessory. The LEDs are not user serviceable. If service is required, we recommend that you have your accessory serviced at a Lionel Factory Trained Authorized Service Station or Lionel Service.
- Page 12 Lionel LLC or any Lionel Authorized Service Station MUST be accompanied by the original receipt for purchase (or copy) from an Authorized Lionel Retailer*, will at the discretion of Lionel LLC, be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a suitable replacement is not available, Lionel will offer to replace the product with a comparable model (determined by Lionel LLC), if available.
Need help?
Do you have a question about the Plug-Expand-Play Sgt Stumpy's Red White & Boom Fireworks and is the answer not in the manual?
Questions and answers