Hooking Up The Tv/Vcr - Magnavox MC13D1MG99 - Tv/vcr Combination - Mono User Manual

MC13D1MG 3/22/02 1:26 PM

6 Hooking Up the TV/VCR

1
Hook up your TV/VCR using one of the connections shown.
A
Hooking Up Your
TV/VCR With a Cable
Signal or Outdoor
Antenna
B
Hooking Up Your
TV/VCR With a Cable
Box
To view any channel, set the
TV/VCR to the Cable Box
output channel (channel 03 or
04). Then, select channels at
the Cable Box.
C
Hooking Up Your
TV/VCR With an
Indoor Antenna
To install a rod antenna (not
supplied), push the stem of
the antenna into the antenna
hole on the top of the
TV/VCR. Connect the anten-
na wire to the ANT(enna)
Jack on the back of the
TV/VCR as shown. Extend the
antenna and adjust its length,
direction, and angle for the
clearest picture.
Page 6
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT Jack
on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.
Connect a Cable signal
or an antenna to the
ANT(enna) Jack.
Connect the Cable signal to
the IN Jack on the Cable Box.
Rod Antenna
(not supplied)
ANT.
IN
OUT
RF coaxial cable
(not supplied)
ANT.
ANT.