Replacement Instructions - Brother CT-1200 Operation Manual

REPLACEMENT INSTRUCTIONS

HOW TO REMOVE / AND RESET THE BOTTOM PLATE
Before replacing any parts, unplug the
vacuum cleaner from the electrical outlet
and set the handle to the Parallel position.
Then turn the vacuum cleaner over, ex-
posing the underside.
REMOVE
Loosen the bottom plate by sliding the
latch away from the mounting screw.
(Fig.30)
Then remove the bottom plate.
RESET
Make sure that all the parts are properly
set and the wires are not pinched.
Insert the front six tabs of the bottom
1
plate into the grooves at the front end
of the nozzle head, then reset the
bottom plate.(Fig. 31)
2 Fasten it by sliding the latch as shown.
(Fig. 30)
HOW TO REPLACE THE HEADLIGHT LAMP
Unplug the vacuum cleaner from the electrical
outlet.
Place the vacuum cleaner in the parallel position.
Remove the lens cover by unscrewing the screw.
1
(Fig. 32)
2
Remove the lamp from the socket by pushing in
gently and turning counterclockwise. (Fig. 33-1)
3
Install the new lamp by pushing it gently into the
socket and turning clockwise. (Fig. 33-2)
Use any standard bayonet base vacuum cleaner
lamp rated 125V, 20W.
4 Replace the lens cover and secure with the
screw.
Latch
B o t t o m
plate
Latch
FASTEN
REMOVE
Screw
1
1
Mounting
screw
Fig.30
Grooves
Tabs
Bottom plate
Fig.31
Lens cover
Fig.32
2
Fig.33-1
2
Fig.33-2
13